13 January 2023 in Physica Scripta
In this study, a highly angular sensitive surface plasmon resonance (SPR) biosensor has been designed for cancer cell detection. The proposed surface plasmon resonance biosensor structure is based on Kretschmann configuration, which works on an angular interrogation technique. The proposed SPR biosensor has enormous possibility to detect the various kind of cancer cells. The refractive index alteration of different cancerous (skin, cervical and blood) cells is 1.360–1.390. The proposed SPR biosensor is stacked with multilayers having CaF2 prism, silver metal, bismuth telluride (Bi2Te3) and MXene (Ti3C2Tx) layers. The performance parameters like angular sensitivity, quality factor, detection accuracy, and electric field intensity distribution have been optimized in this article. Here, various kind of cancer cells (skin, cervical and blood) have been also analyzed and corresponding angular sensitives are 252.20, 305.70 and 319.46 deg R−1IU−1 respectively. The proposed SPR biosensor shows best results for blood cancer cell detection. Some other important performance parameters like detection accuracy, quality factor, and electric field intensity distribution have also been calculated for proposed SPR biosensor device. The simulation results have been performed by MATLAB 2019a software. The proposed SPR biosensor design may open a new way for the medical industry.
19 April 2016 in SpringerPlus
Electrospun fibrous membranes find place in diverse applications like sensors, filters, fuel cell membranes, scaffolds for tissue engineering, organic electronics etc. The objectives of present work are to electrospun polyacrylonitrile (PAN) nanofibers and PAN–CNT nanocomposite nanofibers and convert into carbon nanofiber and carbon-CNT composite nanofiber. The work was divided into two parts, development of nanofibers and composite nanofiber. The PAN nanofibers were produced from 9 wt% PAN solution by electrospinning technique. In another case PAN–CNT composite nanofibers were developed from different concentrations of MWCNTs (1–3 wt%) in 9 wt% PAN solution by electrospinning. Both types of nanofibers were undergone through oxidation, stabilization, carbonization and graphitization. At each stage of processing of carbon and carbon-CNT composite nanofibers were characterized by SEM, AFM, TGA and XRD. It was observed that diameter of nanofiber varies with processing parameters such as applied voltage tip to collector distance, flow rate of solution and polymer concentrations etc. while in case of PAN–CNT composite nanofiber diameter decreases with increasing concentration of CNT in PAN solution. Also with stabilization, carbonization and graphitization diameter of nanofiber decreases. SEM images shows that the minimum fiber diameter in case of 3 wt% of CNT solution because as viscosity increases it reduces the phase separation of PAN and solvent and as a consequence increases in the fiber diameter. AFM images shows that surface of film is irregular which give idea about mat type orientation of fibers. XRD results show that degree of graphitization increases on increasing CNT concentration because of additional stresses exerting on the nanofiber surface in the immediate vicinity of CNTs. TGA results shows wt loss decreases as CNT concentration increases in fibers.
1 September 1998 in Optical Materials
29 December 2015 in Journal of Materials Science: Materials in Electronics
8 April 2010 in Philosophical Magazine Letters
CdSe polycrystalline films have been prepared on ultra-clean glass substrates by a screen-printing technique and then annealed in air. The films prepared by this technique are comparatively thicker than those prepared by other, more sophisticated techniques and optimum conditions for preparing good quality screen-printed films have been found. The optical band gaps (E g) of the films were determined by UV transmission spectroscopy. The zinc-blende structure of the films was confirmed by X-ray diffraction analysis. The Schottky barrier height and the ideality factor for Al/CdSe junctions were determined from current–voltage characteristics. The DC conductivity of the films was measured in vacuum by a two-probe technique.