Ning Yu

Ning Yu

Auto-generated profile, based on publicly available information

Ning Yu

Mechanical and Aerospace Engineering Department, University of California, Los Angeles (UCLA), Los Angeles, California 90095, USA

Research Focus & Metrics

Academic Career Length

32Years (1995-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 December 2020 in Journal of Fluid Mechanics
Verified
Journal Article
Open access
PDF file
MXMuchen Xu
Muchen Xu
NYNing Yu
Ning Yu
JKJohn Kim
John Kim
CKChang-Jin Kim
Chang-Jin Kim
As far as plastron is sustained, superhydrophobic (SHPo) surfaces are expected to reduce skin-friction drag in any flow conditions including large-scale turbulent boundary-layer flows of marine vessels. However, despite many successful drag reductions reported using laboratory facilities, the plastron on SHPo surfaces was persistently lost in high-Reynolds-number flows on open water, and no reduction has been reported until a recent study using certain microtrench SHPo surfaces underneath a boat (Xu et al., Phys. Rev. Appl., vol. 13, no. 3, 2020, 034056). Since scientific studies with controlled flows are difficult with a boat on ocean water, in this paper we test similar SHPo surfaces in a high-speed towing tank, which provides well-controlled open-water flows, by developing a novel , before starting to increase at higher speeds. For a given gas fraction, the trench width non-dimensionalized to the viscous length scale is found to govern the drag reduction, in agreement with previous numerical results.

31 May 2017 in Journal of The Royal Society Interface
Verified
Journal Article
Open access
KNKhoi Nguyen
Khoi Nguyen
NYNing Yu
Ning Yu
MBMahesh Bandi
Mahesh Bandi
MVMadhusudhan Venkadesan
Madhusudhan Venkadesan
SMShreyas Mandre
Shreyas Mandre
How fish modulate their fin stiffness during locomotive manoeuvres remains unknown. We show that changing the fin's curvature modulates its stiffness. Modelling the fin as bendable bony rays held together by a membrane, we deduce that fin curvature is manifested as a misalignment of the principal bending axes between neighbouring rays. An external force causes neighbouring rays to bend and splay apart, and thus stretches the membrane. This coupling between bending the rays and stretching the membrane underlies the increase in stiffness. Using three-dimensional reconstruction of a mackerel (Scomber japonicus) pectoral fin for illustration, we calculate the range of stiffnesses this fin is expected to span by changing curvature. The three-dimensional reconstruction shows that, even in its geometrically flat state, a functional curvature is embedded within the fin microstructure owing to the morphology of individual rays. As the ability of a propulsive surface to transmit force to the surrounding fluid is limited by its stiffness, the fin curvature controls the coupling between the fish and its surrounding fluid. Thereby, our results provide mechanical underpinnings and morphological predictions for the hypothesis that the spanned range of fin stiffnesses correlates with the behaviour and the ecological niche of the fish.

27 April 2023 in Journal of Fluid Mechanics
Verified
Journal Article
Open access
PDF file
NYNing Yu
Ning Yu
ZLZhaohui “Ray” Li
Zhaohui “Ray” Li
AMAlexander McClelland
Alexander McClelland
FMFrancisco Jose del Campo Melchor
Francisco Jose del Campo Melchor
SLSun Youb Lee
Sun Youb Lee
CKChang-Jin Kim
Chang-Jin Kim
This paper studies the sustainability of plastrons on superhydrophobic (SHPo) surfaces made of longitudinal micro-trenches covered by nano-grass with the main interest on hydrodynamic friction drag reduction in high-speed flows of open water, which represent the operating conditions of common watercraft. After revising the shear-driven drainage model to address the air diffusion for SHPo surfaces, the existing theories are combined to reveal the trends of how the immersion depth, air saturation level and shear stress affect the maximum attainable plastron length. Deviations from the theories by the dynamic effect at the two ends of the trench, the interfacial contaminations and turbulent fluctuation are also discussed. A combinatorial series of well-defined SHPo trench surfaces (4 cm × 7 cm in size with varying trench widths, depths, lengths and roughnesses) is microfabricated and attached underneath a 4 m long motorboat on seawater in turbulent flows up to 7.2 m s−1(shear rate ∼83 000 s−1and friction Reynolds number ∼5500). Because the plastron can provide a substantial slip only while its air–water interfaces are pinned (or only slightly depinned) at the trench top, two underwater cameras are employed to differentiate the pinned (and slightly depinned) interfaces from the depinned (and no) interfaces. In addition to achieving pinned plastrons on 6 cm long trenches aligned to high-speed flows in open water, the experimental results corroborate the theoretical estimations, supporting the design of SHPo surfaces for field applications.

11 January 2021 in Langmuir
Verified
Journal Article
Closed access
NYNing Yu
Ning Yu
SKSarina Kiani
Sarina Kiani
MXMuchen Xu
Muchen Xu
CKChang-Jin Kim
Chang-Jin Kim

12 November 2024 in Flow
Verified
Journal Article
Open access
PDF file
NYNing Yu
Ning Yu
FMFrancisco Jose del Campo Melchor
Francisco Jose del Campo Melchor
ZLZhaohui “Ray” Li
Zhaohui “Ray” Li
JJJihun Jeon
Jihun Jeon
JEJeff D. Eldredge
Jeff D. Eldredge
CKChang-Jin Kim
Chang-Jin Kim
Superhydrophobic (SHPo) surfaces can capture a thin layer of air called a plastron under water to reduce skin friction. Although a ~30 % drag reduction has been recently reported with longitudinal micro-trench SHPo surfaces under a boat and in a towing tank, the results lacked the consistency to establish a clear trend. Designed based on Yu et al. (J. Fluid Mech, vol. 962, 2023, A9), this work develops and tests a series of high-performance SHPo surface coupons that can sustain a pinned plastron underneath a passenger motorboat revamped to reach 14 knots. Importantly, plastrons in a pinned state, not just their existence, are confirmed during flow experiments for the first time. All the drag-reduction data measured on different longitudinal micro-trenches are found to collapse if plotted against slip length in wall units. In comparison, aligned posts and transverse trenches show less and little drag reduction, respectively, confirming the adverse effect of the spanwise slip in turbulent flows. This report not only verifies SHPo surfaces can provide a consistent drag reduction at high speeds in open sea but also shows that one may predict the amount of drag reduction in turbulent flows using the physical slip length obtained for Stokes flows.

1 January 1995 in MRS Proceedings
Verified
Journal Article
Closed access
PDF file
William WeberWilliam Weber
William Weber
LWL. M. Wang
L. M. Wang
NYN. Yu
N. Yu
NHN. J. Hess
N. J. Hess