21 October 2015 in Environmental Science: Nano
Mesoporous aluminium magnesium oxide composites with varying composition (Mg content: 0–100%) and high surface area (118–425 m2 g−1) are synthesized by a facile, low-cost and scalable sol–gel method. The mesostructure and crystallinity are controlled by varying the composition and calcination temperature. The mesopores evolve from hexagonally ordered to wormhole-like in structure with increasing Mg/Al ratio. The mesoporous aluminium magnesium oxide composites are highly efficient adsorbents for removing As(V) and As(III) from water. The mesoporous magnesium oxide shows unprecedentedly high adsorption capacities of 912 mg g−1 for As(V) at pH 3 and 813 mg g−1 for As(III) at pH 7 with a dose of 0.5 g L−1; significantly higher than those of reported adsorbents. Exceptional adsorption capacities for arsenic are retained over a wide pH range, and high selectivity for As(V) is realized even in the presence of co-existing anions. The arsenic adsorption performance correlates to the properties of the composites including the Mg/Al ratio, point of zero charge, crystallinity and mesostructure. The arsenic adsorption mechanism is elucidated. Due to their high surface areas, large pore volumes, tunable mesopore structures and high quantities of accessible hydroxyl groups with strong chemisorption binding affinity to arsenic, as well as extremely high adsorption capacities and selectivity, these mesoporous aluminium magnesium oxides are promising adsorbent candidates for the remediation of arsenic in water.
1 November 2021 in Optical Materials
15 September 2015 in ACS Combinatorial Science
15 November 2010 in Applied Physics Letters
The density of charge trapping centers in films deposited by plasma enhanced chemical vapor deposition is investigated as a function of film stoichiometry and postdeposition annealing treatments. In the as-deposited films, the defect density is observed to increase with an increasing N/Si ratio in the range of 0.89–1.45, and to correlate with the N–H bond density. Following the annealing in the temperature range of , the defect density increases for all N/Si ratios, with the largest increase observed in the most Si rich samples. However, the defect density always remains highest in the most N rich films. The better charge storage ability suggests the N rich films are more suitable for the creation of negatively charged nitride films on solar cells.
24 November 2015 in Journal of Materials Chemistry A
The photocatalytic behaviour of titania thin films was studied using a high-throughput method to correlate the effect of pore and thickness modification.
3 August 2022 in Optical Materials