Oxidation can strongly influence the performance of Cu nanowires (CuNWs) by decreasing their conductivity. Here, we identify and investigate a way to prevent the oxidation process of CuNWs to maintain the high conducting performance of CuNWs as transparent electrodes. CuNWs were synthesised using an aqueous method. We prepared several temperature treatments (from 0–300 °C) to represent oxidation of CuNWs in different environments, to study the oxidation process and changes in morphology in detail. Depending on the temperature, smooth and uniform CuNWs exposed to oxidation produced rough Cu₂O and CuO nanowires. We then suggest a method of protecting nanowires from oxidation, using the Mayer rod coating method to apply a layer of PEDOT:PSS to a transparent conducting film of CuNWs. The result indicates that this method of protection can protect the film, and maintain a stable, and constant resistance over of time, without effecting the excellent conductivity properties of pure CuNWs.

The reverse transcription-quantitative polymerase chain reaction (RT-qPCR) approach has been widely used to detect the severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). However, instead of using it alone, clinicians often prefer to diagnose the coronavirus disease 2019 (COVID-19) by utilizing a combination of clinical signs and symptoms, laboratory test, imaging measurement (e.g., chest computed tomography scan), and multivariable clinical prediction models, including the electronic nose. Here, we report on the development and use of a low cost, noninvasive method to rapidly sniff out COVID-19 based on a portable electronic nose (GeNose C19) integrating an array of metal oxide semiconductor gas sensors, optimized feature extraction, and machine learning models. This approach was evaluated in profiling tests involving a total of 615 breath samples composed of 333 positive and 282 negative samples. The samples were obtained from 43 positive and 40 negative COVID-19 patients, respectively, and confirmed with RT-qPCR at two hospitals located in the Special Region of Yogyakarta, Indonesia. Four different machine learning algorithms (i.e., linear discriminant analysis, support vector machine, stacked multilayer perceptron, and deep neural network) were utilized to identify the top-performing pattern recognition methods and to obtain a high system detection accuracy (88–95%), sensitivity (86–94%), and specificity (88–95%) levels from the testing datasets. Our results suggest that GeNose C19 can be considered a highly potential breathalyzer for fast COVID-19 screening.

Electrospun nanofibers of polyvinyl alcohol (PVA) have poor mechanical strength. As such their use has often been avoided, particularly in applications that require high mechanical properties. The objective of this study is to increase the mechanical properties of PVA nanofiber mats via physical crosslinking with solvent vapor treatment using organic solvents, dimethyl sulfoxide (DMSO), N, N-dimethyl formamide (DMF), and methanol. The effect of solvent vapor treatment on PVA nanofibers is clearly observed by scanning electron microscope (SEM). The tensile strength increased by over 60%, 90%, and 115% after solvent vapor treatment with DMF at a temperature of 40 °C for 2 h, 4 h, and 8 h, respectively, compared to untreated PVA nanofibers. In addition, Young's modulus of PVA nanofiber mats also increased after DMF treatment. As a comparison, DMSO and methanol were also used in solvent vapor treatment because of differences in their polymer-solvent affinity. Results showed that the highest improvement (100%) in mechanical strength was obtained using DMF. This study shows that solvent vapor treatment offers a simple and inexpensive method that provides excellent results and is a promising alternative treatment for use in increasing the mechanical properties of electrospun nanofibers.