Proton exchange membrane water electrolysis (PEMWE) is the most promising technology for sustainable hydrogen production. However, it has been too expensive to compete with current state-of-the-art technologies due to the high cost of titanium bipolar plates (BPPs) and porous transport layers (PTLs). Here, we report a high-performance, durable and low-cost PEMWE cell with coated stainless steel (ss) BPPs and PTLs. When using uncoated ss components in the PEMWE cell, the cell depolarizes rapidly, reaching 2 V at only 0.15 A cm−2. After the application of non-precious metal coatings of Ti and Nb/Ti on the ss-BPP and ss-PTL, respectively, the current density can be increased by a factor of 13 while maintaining the same performance. Extensive physical and electrochemical characterization supported by pore network modelling shows that the Nb/Ti coating on the ss-PTL leads to efficient water and gas transport at the interface with the anode. The PEMWE cell with coated ss components was evaluated in an accelerated stress test (AST) for more than 1000 h. No sign of Fe contamination in either the membrane or the electrodes is observed at the end of the test. With our results, we demonstrate that PEMWE cells can be manufactured almost entirely in ss, facilitating an unprecedented cost reduction in this technology and advancing the widespread use of green H2.
1 February 2021 in Journal of Materials Chemistry A
A-site deficient chromite La0.65Sr0.3Cr0.85Ni0.15O3−δ (L65SCrN) decorated by in situ Ni exsolution was implemented as fuel electrode on 5 cm × 5 cm reversible electrolyte-supported solid oxide cells (rSOCs).
Deciphering electrochemical processes at the surface of Ba0.5Gd0.8La0.7Co2O6−δto design a high performance oxygen electrode for reversible proton conducting ceramic cells.
15 November 1999 in Journal of the Physical Society of Japan
Protonic ceramic cells (PCCs) offer variety of potential applications for electrochemical energy conversion, however a lot of challenges remain in the development of PCCs for industrial scale manufacturing processes. As it was successfully demonstrated for the solid oxide cells, metal supported architecture is a good alternative for PCCs with many attractive advantages in terms of stabilities in operation and reduction of raw critical materials. In this review, proposed architectures, component materials and processing options are summarized. The challenges and prospects are discussed.
Metal-Supported (MS) architecture offers various advantages over state-of-the-art ceramic supported SOCs, such as high tolerance towards thermal/redox cycling that are key features for flexible and reliable operation in high temperature fuel cell and electrolysis applications. Our target is to develop Proton-conducting Ceramic Cells (PCC) in MS architecture, of which combination can provide potentially high performances, mechanical stability, and flexibility for wide range of electrochemical applications. The key challenge in the development of MS-PCC is to find a feasible process to fabricate gas-tight electrolyte on the porous metal substrate without degrading the metal support and the electrolyte. Our strategy is implementing multilayers combining wet chemical processes below 1000°C for the functional electrode and dry Physical Vapor Deposition (PVD) techniques below 800°C for the gas-tight electrolyte coating. In this paper, we present our recent results in the development of MS-PCC half cells. The materials selection for MS and PCC components, functional layer processing, and electrolyte layer deposition techniques are discussed.