This paper describes a high-accuracy airflow volumetric flowmeter using piezoelectric micromachined ultrasound transducers (pMUTs) arrays based on the transit-time. Two pieces of 10by10 multipled aluminum nitride (AlN) pMUTs arrays at resonant frequency of 980 kHz are employed to transmit and receive ultrasonic signals alternately. The dimension of the fabricated 10by10 array is about $3.5\times 3.5\ \text{mm}^{2}$ , so the pMUTs-based flowmeter can conveniently measure the flow rate in small pipes. Leveraging on the high signal to noise ratio (SNR, ∼29 dB) of the pMUTs and good resolution (ns) of the evaluation board, the flowmeter has high accuracy. The relative errors of the correctional volumetric flow are within 3% for the reference flow rate in the range from 0–9 L/min in a pipe with a diameter of 10 mm.
30 January 2018 in Mathematical Problems in Engineering
This paper studies the problem of fixed-time stability of hydraulic turbine governing system with the elastic water hammer nonlinear model. To control and improve the quality of hydraulic turbine governing system, a new fixed-time control strategy is proposed, which can stabilize the water turbine governing system within a fixed time. Compared with the finite-time control strategy where the convergence rate depends on the initial state, the settling time of the fixed-time control scheme can be adjusted to the required value regardless of the initial conditions. Finally, we numerically show that the fixed-time control is more effective than and superior to the finite-time control.
This paper presents a comparison of the energy harvesting capabilities of 3 different electrostatic mechanisms based on MEMS (microelectromechanical system) structures which are designed and operated in idea vacuum. The 3 mechanisms that will be compared are the in-plane overlap, in-plane gap closing and out-of-plane gap closing mechanisms. Firstly, it was found that the in-plane gap closing mechanism potentially has the highest output energy amongst the 3 different mechanisms. Secondly, the best energy output for the in-plane gap closing mechanism is approximately 1.8 times that of the out-of-plane gap closing mechanism for load volumes between 5 mm3 and 50 mm3.