18 November 2013 in Journal of Sandwich Structures & Materials
This paper analyzes the bending response of functionally graded skew sandwich plates with graded layer as face sheet/core using higher order shear deformation theory in the frame work of finite element method considering through-the-thickness variation of displacements. The assumed kinematics field incorporates the quadratic variation of thickness co-ordinate in defining the transverse displacement. The C0 finite element formulation has been done efficiently to overcome the problem of C1 continuity associated with the higher order shear deformation theory. For this, a rectangular isoparametic Lagrangian element with nine nodes and 13 nodal unknowns at each node is developed. Two types of plates are modeled: functionally graded skew plates with graded face sheets and graded layer as core part. By considering the symmetry of the plate, different combinations of bottom-core-top thickness has been considered for the numerical study. Wide variety of numerical problems are presented for functionally graded sandwich plates with various skew angles, thickness schemes, aspect ratio, thickness ratio and boundary conditions. It is noticed that isotropic plates exhibit diverge response in comparison with graded plates. Also, power law exponent and skew angle are vital parameters that dictate the response of the plate under bending.
1 July 2013 in Journal of Engineering Mechanics
The static and dynamic analysis of functionally graded material (FGM) skew plates under mechanical load is studied. The FEM formulation based on a third-order shear deformation (TOSD) theory that does not require any shear correction factor is used in the analysis. The continuity requirement of the higher-order theory has been overcome in this study by adopting a continuous isoparametric Lagrangian element with seven degrees of freedom at each node. The Mori-Tanaka homogenization scheme is used to estimate the effective properties of the constituents, and it is assumed that mechanical properties vary according to a power-law distribution of the volume fraction of the constituents. The efficiency of the present model has been validated by comparing the results obtained with those available in the literature. The effects of skew angle, boundary conditions, volume-fraction exponent, loading conditions, aspect ratio, thickness ratio, and other parameters on deflection, natural frequency, and critical buckling load of functionally graded skew plates are reported for the first time based on TOSD that can serve as the benchmark for future research.
3 December 2013 in International Journal of Applied Mechanics
9 September 2016 in Mechanics of Advanced Materials and Structures
In this study, a simple C0 isoparametric finite element formulation based on higher-order shear deformation theory is presented for static analysis of functionally graded material sandwich shells (FGMSS). To characterize the membrane-flexure behavior observed in a functionally graded shell, a displacement field involving higher-order terms in in-plane and transverse fields is considered. The proposed kinematics field incorporates for transverse normal deformation, transverse shear deformation, and nonlinear variation of the in-plane displacement field through the thickness to predict the overall response of the shell in an accurate sense. To develop the efficient C0 formulation, the derivatives of transverse displacement are treated as independent field variables (nodal unknowns). Voigt's rule of mixture is employed to ascertain the mechanical properties of each layer's constituents along the thickness direction. A wide range of numerical problems are solved assuming various parameters: side-thickness ratio, curvature-side ratio, and gradation parameter, and their interactions with regard to static analysis of FGMSS are discussed in brief. Deflection and stresses incorporating different thickness schemes of sandwich shells are presented in the form of figures. To validate the results, a functionally graded shell without sandwich arrangement is considered. Since no results are available on static analysis of FGMSS, the present 2D model based on the finite element method might be helpful in assessing the applicability of other analytical and numerical models in this area in the future.