1 April 2015 in Journal of Turbomachinery
4 November 2015 in Journal of Hydraulic Research
The paper addresses unsteady pressure measurements on the blades and stationary parts of a Kaplan turbine model (Porjus U9) during load variation. The turbine was studied in various load acceptance and load rejection scenarios in off-cam mode to investigate the effect of the transients on the turbine performance. The formation and mitigation processes for the rotating vortex ropes and their effects on the forces exerted on the runner were also investigated. The results show a smooth transition during load variations between high load and the best efficiency point, at which no rotating vortex ropes form in the draft tube. However, load variation to part load resulted in a draft tube surge and the formation of a rotating vortex rope with two fluctuating components: rotating and plunging. The rotating vortex ropes began to form at the end of the draft tube cone during the closure of the guide vanes and travelled upstream with further guide vane closure. The plunging mode induced flow oscillation throughout the entire turbine conduit, whereas the rotating mode resulted in local pressure fluctuations. The rotating vortex ropes induced wide-band pressure fluctuations on the suction side of the runner close to the hub section. The formation of the rotating vortex ropes near the runner resulted in a sudden change in the pressure exerted on the suction side of the blades, whereas the rotating vortex rope mitigation process proceeded in a smooth manner.
1 June 2018 in Computer Methods in Applied Mechanics and Engineering
4 July 2018 in Journal of Hydraulic Research
This paper investigates water hammer flows using two- and three-dimensional (2D and 3D) numerical simulations. The unsteady Reynolds-averaged Navier–Stokes (URANS) equations in conjunction with the k–ω SST turbulence model are employed for the computations. The valve modelling approach is used for 3D simulations, with superior agreement with the experiments. Similar predictions are obtained by 2D simulations and the flow rate reduction curve obtained from the 3D computations. The asymmetric flow patterns induced by the valve are confined within approximately one pipe diameter upstream of the valve. The contributions of inertia and pressure gradient terms are dominant at the instance of pressure wave passage, leading to abrupt changes in the fluid flow parameters. However, the effects of inertia and viscous shear stress terms are significant after the pressure wave passage, resulting in the flow tendency to approach a new steady condition. The viscous and turbulent dissipations are dominant close to and away from the wall, respectively.
1 February 2019 in Applied Thermal Engineering
1 October 2019 in Renewable Energy