Optical fiber–based sensing technology can drastically improve Earth observations by enabling the use of existing submarine communication cables as seafloor sensors. Previous interferometric and polarization-based techniques demonstrated environmental sensing over cable lengths up to 10,500 kilometers. However, measurements were limited to the integrated changes over the entire length of the cable. We demonstrate the detection of earthquakes and ocean signals on individual spans between repeaters of a 5860-kilometer-long transatlantic cable rather than the whole cable. By applying this technique to the existing undersea communication cables, which have a repeater-to-repeater span length of 45 to 90 kilometers, the largely unmonitored ocean floor could be instrumented with thousands of permanent real-time environmental sensors without changes to the underwater infrastructure.
Nonadiabatic decay rates for a radio-frequency-dressed magnetic trap are calculated using Fermi's golden rule: that is, we examine the probability for a single atom to make transitions out of the dressed trap and into a continuum in the adiabatic limit, where perturbation theory can be applied. This approach can be compared to the semiclassical Landau-Zener theory of a resonant dressed atom trap, and it is found that, when carefully implemented, the Landau-Zener theory overestimates the rate of nonadiabatic spin-flip transitions in the adiabatic limit. This indicates that care is needed when determining requirements on trap Rabi frequency and magnetic-field gradient in practical atom traps.
Distributed cavity phase (DCP) frequency shifts are a leading systematic effect in atomic fountain frequency standards. They originate from the phase variations of the field in the microwave cavity combined with different positions of the atoms in the cavity on the ascent and descent. Here we demonstrate techniques to precisely determine the position of the cloud of atoms in the microwave cavity, using either the approximately linear variation of the transverse components of the microwave field or the quadratic variation of the longitudinal microwave field amplitude in the cavity. We also show that shifting the initial position of the atoms gives a significantly higher sensitivity to DCP variations than the often-used tilting of fountains. A demonstrated centring precision of order 50 μm will enable DCP frequency shift uncertainties to be reduced to less than 10 –17 and thereby contribute insignificantly to the accuracy budget of a standard. These techniques to vertically align a fountain are straightforward to automate for routine operation and require a negligible fraction of the standard’s averaging time.