We present the manufacturing and utilization of an all-polymer arrayed waveguide grating (AWG) interacting with a fiber Bragg grating (FBG) for battery status monitoring on the example of a 40 Ah lithium-ion battery. The AWG is the main component of a novel low-cost approach for an optical interrogation unit to track the FBG peak wavelength by means of intensity changes monitored by a CMOS linear image sensor, read out by a Teensy 3.2 microcontroller. The AWG was manufactured using laser direct lithography as an all-polymer-system, whereas the FBG was produced by point-by-point femtosecond laser writing. Using this system, we continuously monitored the strain variation of a battery cell during low rate charge and discharge cycles over one month under constant climate conditions and compared the results to parallel readings of an optical spectrum analyzer with special attention to the influence of the relative air humidity. We found our low-cost interrogation unit is capable of precisely and reliably capturing the typical strain variation of a high energy pouch cell during cycling with a resolution of 1 pm and shows a humidity sensitivity of −12.8 pm per %RH.
Integrated ring resonators and Mach-Zehnder interferometers are sensing schemes utilizing the interaction of the evanescent field with liquid or gaseous substances surrounding the sensor. Using different simulation software programs, waveguide properties such as single-mode behavior and mode profile are investigated and different loss mechanisms and their impact on the sensor design are discussed
This Letter describes the design, production, and characterization of a arrayed waveguide grating (AWG) for fiber Bragg grating (FBG) readout, centered at 850 nm, with a channel spacing of 1 nm. The employed manufacturing process is laser direct lithography, a low-cost, rapid-prototyping capable, maskless method that allows for short iteration cycles and simple migration of a successful design to mask-based high throughput methods. We also consider the achievable AWG performance if used for strain or temperature measurements with FBG sensors.