The ultrasonic spot welding of fiber-reinforced thermoplastic laminates received a wide interest from researchers mainly in the fields of aerospace and automotive industries. This study investigated a new technique for focusing the ultrasonic vibration energy at the desired spot between two mating thermoplastic composite laminates. In this investigated method, no additional energy directing protrusions between the mating laminates were required to focus the vibration energy. It was found that by welding the laminates amid an ultrasonic horn and an anvil in which the prior had a larger contact surface with the laminate as the latter, it was possible to generate a localized friction heating. In the initial phase of the welding, the friction heating softened the interfacial layers and thus caused the focusing of the majority of the cyclic ultrasonic strain energy in the weld spot center. The assumption for the presence of the friction and its influence on the heat generation was investigated by means of finite element method (FEM) mechanical dynamic analysis. Microscopic analysis of the weld spot eventually delivered the proof for the melt initiation by friction at a ring around the weld spot and subsequent spot growth by viscoelastic heating.
1 January 2017 in Composites Part A: Applied Science and Manufacturing
In aero engines, noise absorption is realised by acoustic liners, e.g., Helmholtz resonator (HR) liners, which often absorb sound only in a narrow frequency range. Due to developments of new engine generations, an improvement of overall acoustic damping performance and in particular more broadband noise absorption is required. In this paper, a new approach to increase the bandwidth of noise absorption for HR liners is presented. By replacing rigid cell walls in the liner’s honeycomb core structure by flexible polymer films, additional acoustic energy is dissipated. A manufacturing technology for square honeycomb cores with partially flexible walls is described. Samples with different flexible wall materials were fabricated and tested. The acoustic measurements show more broadband sound absorption compared to a reference liner with rigid walls due to acoustic-structural interaction. Manufacturing-related parameters are found to have a strong influence on the resulting vibration behaviour of the polymer films, and therefore on the acoustic performance. For future use, detailed investigations to ensure the liner segments compliance with technical, environmental, and life-cycle requirements are needed. However, the results of this study show the potential of this novel liner concept for noise reduction in future aero-engines.
Structural supercapacitors (SSCs) are multifunctional energy storage composites (MESCs) that combine the mechanical properties of fiber-reinforced polymers and the electrochemical performance of supercapacitors to reduce the overall mass in lightweight applications with electrical energy consumption. These novel MESCs have huge potentials, and their properties have improved dramatically since their introduction in the early 2000’s. However, the current properties of SSCs are not sufficient for complete energy supply of electrically driven devices. To overcome this drawback, the aim of the current study is to identify key areas for enhancement of the multifunctional performance of SSCs. Critical modification paths for the SSC constituents are systematically analyzed. Special focus is given to the improvement of carbon fiber-based electrodes, the selection of structural electrolytes and the implementation of separators for the development of more efficient SSCs. Finally, current SSCs are compared in terms of their multifunctionality including material combinations and modifications.