10 October 2008 in IEEE Transactions on Instrumentation and Measurement
Up to now, vibrations have mostly been sensed by measuring displacement, velocity, and acceleration. The most common types of vibration sensors are piezoelectric, capacitive, null-balance, strain gage, optoelectronic, resonance beam, and piezoresistive. We present a low-cost and low-power vibration detector based on the measurement of magnetic field variations induced in a recent SS501 giant magnetoresistance (GMR) magnetic sensor, for which has never been applied. Vibrations on small ferromagnetic pieces disturb the Earth's magnetic field. These weak perturbations can be detected and measured over the assumed constant Earth's magnetic field, which is uniform over a wide area. A novel array configuration of three half-bridge GMR sensors powered in chain is used to measure magnetic field variations in the X-, Y-, and Z-axis with a very low power consumption. This paper includes a characterization of the novel GMR sensors and describes the practical design and implementation of a vibration detector. Two examples demonstrate the utility of these sensors: one for measuring the rotating speed of a small drilling machine and its vibrations at different speeds (in revolutions per minute) and the other one for measuring the characteristic 440-Hz vibration of a tuning fork (A key), which is used to tune musical instruments. The results are shown and discussed.
1 July 2007 in Sensors and Actuators A: Physical
2 October 2014 in IEEE Sensors Journal
In this paper, we propose a method for obtaining an analytic model of the battery state-of-charge in wireless sensor nodes. The objective is to find simple models that can be used to estimate accurately the real battery state and consequently the node lifetime. Running the model in the network nodes, we can provide the motes with the required information to implement applications that can be considered as battery-aware. The proposed methodology reduces the computational complexity of the model avoiding complicated electrochemical simulations and treating the battery as an unknown system with an output that can be predicted using simple mathematical models. At a first stage, during a setup period, the method starts with the measurement of several battery parameters under different environmental and operational conditions. After that, the method uses the previous collected data for building mathematical models, considering the linear regression or multilayer perceptron as the most appropriated. Finally, the models are validated experimentally with new measures. Results show the suitability of the method that produces accurate and simple models, capable of being implemented even in low cost and very constrained real motes.