Rachna Singh

Rachna Singh

Auto-generated profile, based on publicly available information

Rachna Singh

Department of Electronics and Communication Engineering, Jaypee Institute of Information Technology, Noida, Uttar Pradesh, India

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2025 in International Journal of Energy Research
Verified
Journal Article
Open access
RSRachna Singh
Rachna Singh
AJAlok Joshi
Alok Joshi
GGGunjan Gupta
Gunjan Gupta
In solar cells, efficiency is the most critical parameter. In single‐junction solar cells, efficiency is always limited, so to increase the efficiency beyond a specific range, we need to switch to a tandem configuration. Tandem configuration is the stacking of two different cells together, termed as top and bottom cells, where the electrical properties of these two cells are different. ln this paper, free perovskite material with a wide band gap of 1.5 eV (CsSnGeI 3 ) is used to make the top cell, and a narrow band gap of 1.12 eV crystalline silicon is used to create a bottom cell. The advantage of using perovskite material is its high light conversion rate, which leads to better efficiency. Power conversion efficiency (PEC) for perovskite cells is up to 30%. The proposed cell is simulated by SCAPS‐1D. In this process, the top and bottom cells are calibrated in the standalone conditions before analyzing the tandem configuration, where the optimized thickness for the top cell is 100 nm and that of the bottom cell is 200 nm. To combine both cells, the current of both cells should be matched, where the top cell current acts as a limiting factor. By changing the width of the top cell for a filtered spectrum and integrated filtered power, a matched current of 18.34 mA cm −2 is obtained for the top/bottom cell. The resultant parameters of the proposed tandem solar cell are PCE of approximately 26%, open circuit voltage ( V oc ) of 1.576 V, fill factor (FF) of 90%, and short circuit current ( J sc ) of 18.34 mA cm −2 . The proposed device can help develop low‐cost applications and high‐efficiency tandem solar cells.

15 September 2025 in IEEE Open Journal of Vehicular Technology
Verified
Journal Article
Open access
LRLeuva Bhumika Ranchhodbhai
Leuva Bhumika Ranchhodbhai
DSDharmendra Sadhwani
Dharmendra Sadhwani
RSRachna Singh
Rachna Singh
Reconfigurable Intelligent Surfaces (RISs) have emerged as a promising solution to enhance the security and reliability of wireless communication systems by intelligently reshaping the propagation environment. Although conventional passive RIS improves signal's strength through phase-shift control, its inability to amplify signals limits the overall system's performance. This limitation is addressed by the active RIS, which integrates amplification capabilities to offer significant performance enhancements. With the help of novel recursive integrals, this paper presents accurate yet analytically tractable closed-form solutions for the outage probability (OP) and the secrecy outage probability (SOP) for active RIS-aided wireless communication systems under Nakagami-$m$ fading conditions. To achieve the same level of target reliability of 0.4, we demonstrate that under certain degrees of the fading severity, and at some constant value of the receiver's signal-to-noise ratio (SNR), an active RIS-aided structure with amplification gain of 10 dB help in reducing the required number of reflecting elements by nearly 90% compared to its passive counterpart. This underscores the practical and economic advantages of active RIS in terms of reduced hardware complexity and deployment cost. The number of elements needed can be further reduced by increasing the amplification gain of the active reflecting elements. Additionally, the asymptotic receiver SNR analysis is carried out which further provides an insight into the advantages of incorporating active reflecting elements into the system's design as compared to the corresponding passive elements. Precisely, for the same number of elements, the active RIS-aided systems achieve a considerable user's SNR of 40 dB as compared to the passive RIS-aided systems; for all values of the Nakagami-$m$ fading parameters. All the analytical results are validated through extensive Monte-Carlo simulations.