The quality of strain measurements using distributed fiber optic sensors (DFOS) depends largely on the bond between the host material and the optical fiber. Experimental investigations were carried out to test the suitability of five different DFOS types for crack monitoring. The DFOS were subsequently bonded to two 4 m long reinforced concrete (RC) beams, so that the influence of the application technique could be evaluated. DFOS measurements were verified by digital image correlation (DIC) and electrical strain gauges (SGs). For the different DFOS types, clear differences in the measured strain curves and determined crack widths were observed. The focus was on two robust DFOS, which can be deployed on construction sites. Compared to the layered sensing cable, a monolithic DFOS showed a clear strain distribution with pronounced strain peaks even for closely spaced cracks. The crack widths obtained by integrating the strain curves showed high agreement with DIC measurements.
The article describes measurements of strains of concrete, steel and textile reinforcement with distributed fiber optic sensors (DFOS). The technology of distributed strain measurements gains currently increasing attention within the civil engineering field and indeed the DFOS can be applied in various measurement scenarios providing results and insights which were not possible before. Within this article, the fibers and adhesives that are most commonly used are compared and several measurement scenarios and their results are described, including precise strain measurements with high resolution as well as measurements on large‐scale specimens. Concrete strains were measured in a multiaxial compression stress state and also during setting and hardening and in flexural tests. Strains of the steel and textile reinforcement were monitored along the bond zone and also in flexural tests. Finally, cracking patterns were observed and compared with digital image correlation methods. Validated examples of applications of DFOS in laboratory work are described.
Two test series were examined using nondestructive measuring methods by six independent laboratories before determining their compressive strength. The nondestructive test methods used were the rebound hammer and ultrasonic pulse velocity measurement. Two types of geometries were investigated: drilled cores and cubes. The measurement procedure for each of these datasets is conditioned to the geometry and is therefore different.