Seokjae Song

Seokjae Song

Auto-generated profile, based on publicly available information

Seokjae Song

Department of Electrical Engineering, Hanyang University, Ansan, South Korea

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 December 2020 in IEEE Access
Verified
Journal Article
Open access
JKJaedo Kim
Jaedo Kim
SSSeokjae Song
Seokjae Song
Jeongjin RohJeongjin Roh
Jeongjin Roh
This paper presents a class-AB operational transconductance amplifier (OTA) with a high slew rate. The proposed class-AB OTA is applied with a slew-rate enhancement technique using an extremely low quiescent current. The additional current-reference common-mode feedback loop resolves the susceptibility to process, voltage, and temperature fluctuations resulting from slew-rate enhancement transistors. The proposed class-AB OTA is most widely used in block design, including, a switched-capacitor circuit, analog-to-digital converter, digital-to-analog converter, low-dropout regulator, and switched-capacitor DC-DC converters. In this study, performance was validated by applying the proposed class-AB OTA to a switched-capacitor delta-sigma modulator which requires high performance and high precision. The circuit was designed and simulated using a 0.18-μm complementary metal-oxide semiconductor process.

8 March 2021 in IEEE Access
Verified
Journal Article
Open access
SSSeokjae Song
Seokjae Song
JKJaedo Kim
Jaedo Kim
Jeongjin RohJeongjin Roh
Jeongjin Roh
This paper presents a high-resolution analog front-end (AFE) circuit operating in the 25 kHz signal bandwidth. The AFE consists of a capacitively-coupled chopper instrumentation amplifier (CCIA) and a third-order delta-sigma modulator (DSM). Signal distortion often occurs at the junction of CCIA and DSM, so the resistor-based discrete-time DSM (RB DT–DSM) is proposed to solve this problem. Both conventional DT–DSM and the proposed RB DT–DSM are designed and compared through simulations and chip measurements. When a conventional DT–DSM is used, a switched-capacitor integrator with a large capacitor and switch are connected to the CCIA output node, so large switching noise, significant charge injection, and a long settling time occur at the CCIA output, resulting in harmonic distortions. Therefore, CCIA requires more power consumption to reduce the settling time for conventional DT–DSM architectures. On the other hand, when the proposed RB DT–DSM is used, only a resistor and a small switch are connected to the CCIA output. Due to this novel interface technique, the switching noise is very small at the CCIA output, and the settling of the CCIA becomes fast. As a result, it is possible to effectively eliminate harmonic distortions while reducing the power requirement of the CCIA. Both the conventional and proposed AFE circuits were manufactured by a 0.18- $\mu \text{m}$ complementary metal-oxide-semiconductor (CMOS) process. The conventional AFE shows a peak SNR of 101.1 dB and a peak SNDR of 91.2 dB. The proposed AFE with RB DT–DSM shows a peak SNR of 101.3 dB and a peak SNDR of 100.5 dB, which verifies the significant reduction in harmonic distortions.