23 November 2022 in IEEE Transactions on Microwave Theory and Techniques
This article presents a 32-element 28/39-GHz dual-band phased array for fifth-generation (5G) communication systems. The array is based on separate sets of SiGe transmit/ receive (Tx/Rx) beamformer chips to realize independent dual-beamforming capabilities at orthogonal linear polarizations. The beamformer chips are integrated with an $8$ $\times$ $4$ dual-band stacked patch antenna array on a low-cost printed circuit board (PCB) and grouped together using two different Wilkinson networks to form two separate beamforming systems. The dual-band array demonstrates a measured effective isotropic radiated power (EIRP) of 40–42 dBm at the 28-and 39-GHz bands. The array is capable of scanning $\pm$ 55 $^{\circ}$ in the 28-GHz band and $\pm$ 40 $^{\circ}$ in the 39-GHz band, both in the azimuth plane. In simultaneous dual-frequency dual-beam operation with the 28-GHz band on the V-pol. and the 39-GHz band on the H-pol., spectrum measurement shows that the array has no visible intermodulation products between the 28-and 39-GHz beams. Also, complex modulation measurements with 64-QAM waveforms show $<$ 3% error vector magnitude (EVM) at an EIRP of up to 36-dBm EIRP for both beams radiating together and without interference with each other. This work demonstrates the first millimeter-wave (mm-wave) 5G dual-band array and paves the way toward multistandard systems.
16 March 2023 in IEEE Transactions on Microwave Theory and Techniques
This article presents an eight-element, 28-/39-GHz dual-band, dual-polarized phased array for user equipment, such as computers, cell phones, or other small base stations. The array is based on a dual-band stacked-patch antenna, which can operate simultaneously at 28 and 39 GHz in both polarizations, meeting the fifth-generation (5G) $2\ttimes 2$ polarization multiple-input–multiple-output (MIMO) standard at both frequencies. The array is fabricated on a low-cost printed-circuit board and has a measured effective isotropic radiated power (EIRP) of 27–30 dBm at P1dB with a 3-dB bandwidth of 26.5–29 and 36–40 GHz. The array scans to $\pm$ 40 $^{\circ}$ at 28 GHz and $\pm$ 30 $^{\circ}$ –40 $^{\circ}$ at 39 GHz in the azimuth plane. In simultaneous dual-beam operation at the same band, complex modulation measurement with 64 quadrature amplitude modulation (QAM) 400-Mbaud waveforms shows an error vector magnitude (EVM) of $<$ 5% up to an EIRP of 20 dBm for the V-and H-polarized beams. The array needs to be calibrated at 28-and 39-GHz band separately so is currently incapable of interband carrier aggregation (CA). To the best of authors’ knowledge, this is the first demonstration of a 5G frequency range 2 (FR2) dual-band, dual-polarized active phased array.
21 May 2024 in IEEE Transactions on Microwave Theory and Techniques
This article presents a 23–46-GHz, $8\ttimes 8$ single-polarized wideband bow-tie phased array designed to support multistandard fifth-generation (5G) communications. The array is built by integrating SiGe BiCMOS Tx/Rx beamformer chips with stacked differential bow-tie antennas on a single printed circuit board (PCB). The array is capable of $\pm$ 55 $^{\circ}$ and $\pm$ 35 $^{\circ}$ scanning in the azimuth plane and the elevation plane and achieves an effective isotropic radiated power (EIRP) of 42–48 dBm at P1 dB at 23–46 GHz. In the Rx mode, the array yields a peak G/T of $-$ 10 and $-$ 14 dB/K from 23 to 46 GHz. Measurements on 16/64/256-QAM modulated waveforms show $<$ 5% EVM and 42–45-dBm average EIRP with a peak data rate of 3.2 Gb/s. The array also transmits 5G OFDM 400-MHz waveforms with a PAPR of 11 dB at an EIRP of 40–44 dBm and 3.5% EVM, making it ideal for use as small base stations. To the authors’ knowledge, this work achieves the widest bandwidth among the reported planar phased arrays with application areas to multistandard 5G systems.
19 May 2025 in IEEE Transactions on Antennas and Propagation
This paper presents wideband single and dual-polarized phased-arrays for multiband 5G systems. The antenna element incorporates a dipole-fed split-ring multimode resonator (SRR), enabling continuous operation in the 22-46 GHz (N257-N261 bands). The antenna is fabricated using a low-cost printed-circuit board, which facilitates interconnection with the TX/RX beamformer. For demonstration, the single-polarized antenna is employed in an 8 × 8 phased array, while the dual-polarized antenna is implemented in a 4 × 2 phased array. Post-calibration measurements show that the single-polarized 8 × 8 phased array exhibits an EIRP of 42-48 dBm and a scanning capability exceeding 55° at 22-46 GHz, which is ideal for customer premises equipment (CPE) application. The dual-polarized phased array achieves a saturated EIRP of 23-32 dBm at 21-44 GHz for each polarization. The high polarization isolation supports 2 × 2 multiple-input multiple-output (MIMO) applications. System level measurements were conducted using 5G-NR and 64 QAM modulation at 400 Mbaud. The dipole-fed SRR antenna offers the broadest operational bandwidth among single and dual-polarized planar phased array designs, making it a strong candidate for multi-standard 5G applications.