The purpose of this article is to discuss the design guideline and design chart of the digital peak current mode dc–dc converter using a current–frequency conversion by analyzing its static characteristics. The operation of the proposed method is expressed by equations, and the relationships between controller parameters are derived. This discussion reveals the relationships between the peak current instruction value and the output voltage or peak current, which are necessary for designing the proposed method. Then, the design guideline and design chart are given. The validity of the static characteristic analysis is demonstrated by a prototype, whose design follows the design guideline. An appropriate operation in the steady and static state is also indicated by the experiment. As a result, the validity of the static characteristics and the design guideline of the proposed method can be verified.
The boost type dc-dc converter is used for compensation of dc bus voltage in the dc power feeding system such as the renewable energy system. It should be operated stably to improve reliability of the system. The peak current mode control is applied to operate stably because the boost type dc-dc converter tends to be unstable. However, a peak value of reactor current cannot be captured in the digital controller. In this paper, a digital peak current mode control boost converter with conversion from current to frequency and using a frequency detector for a peak current detection in real time is presented. The effectiveness of the proposed method is verified by the comparison of the transient response under changing an input voltage between the conventional PID control and the proposed method.
The renewable energy has been attracted attention as a solution of global warming because it can suppress the carbon dioxide emissions. The renewable energy should be optimized by the energy management in the renewable energy system. The digital peak current mode control dc-dc converter is presented to realize the stable operation in this system considering the variation of the input voltage condition in this paper. The stability of the power supply system is kept by the peak current mode control when the integral gain is set to a large value to keep a wide regulation range. The waveform of the output voltage changes from an oscillatory response to a gentle one in comparison between the conventional voltage mode control and the proposed method because the stability is improved. As a result, the proposed method has an advantage under changing the input voltage condition such as the renewable energy system.
The authors have proposed the series-parallel dc-dc converter as an elemental technology to develop the power supply system that is highly compatible with renewable energy. However, when the series-parallel dc-dc converter is operated, there is an issue that the input voltage is not shared evenly by each dc-dc converter unit that consists of the series-parallel dc-dc converter. The aim of this paper is to analyze the causes of input voltage unevenness under specific conditions. By analysis of the current path through simulation, it is found that the charge and discharge of the input capacitor of each dc-dc converter unit occur, and it became clear that this leads the unevenness in the sharing of the input voltage.