Using a superconducting circuit, the Josephson mixer, we demonstrate the first experimental realization of spatially separated two-mode squeezed states of microwave light. Driven by a pump tone, a first Josephson mixer generates, out of quantum vacuum, a pair of entangled fields at different frequencies on separate transmission lines. A second mixer, driven by a $\pi${}-phase shifted copy of the first pump tone, recombines and disentangles the two fields. The resulting output noise level is measured to be lower than for the vacuum state at the input of the second mixer, an unambiguous proof of entanglement. Moreover, the output noise level provides a direct, quantitative measure of entanglement, leading here to the demonstration of 6\,\,Mebit\ifmmode\cdot\else\textperiodcentered\fi{}s-1 (mega entangled bits per second) generated by the first mixer.
We demonstrate a hybrid architecture consisting of a quantum dot circuit coupled to a single mode of the electromagnetic field. We use single wall carbon nanotube based circuits inserted in superconducting microwave cavities. By probing the nanotube dot using a dispersive readout in the Coulomb blockade and the Kondo regime, we determine an electron-photon coupling strength which should enable circuit QED experiments with more complex quantum dot circuits.
We present the first experimental realization of a widely frequency tunable, nondegenerate three-wave mixing device for quantum signals at gigahertz frequency. It is based on a new superconducting building block consisting of a ring of four Josephson junctions shunted by a cross of four linear inductances. The phase configuration of the ring remains unique over a wide range of magnetic fluxes threading the loop. It is thus possible to vary the inductance of the ring with flux while retaining a strong, dissipation-free, and noiseless nonlinearity. The device has been operated in amplifier mode, and its noise performance has been evaluated by using the noise spectrum emitted by a voltage-biased tunnel junction at finite frequency as a test signal. The unprecedented accuracy with which the crossover between zero-point fluctuations and shot noise has been measured provides an upper bound for the noise and dissipation intrinsic to the device.
Making a system state follow a prescribed trajectory despite fluctuations and errors commonly consists of monitoring an observable (temperature, blood-glucose level, etc.) and reacting on its controllers (heater power, insulin amount, etc.). In the quantum domain, there is a change of paradigm in feedback, since measurements modify the state of the system, most dramatically when the trajectory goes through superpositions of measurement eigenstates. Here, we demonstrate the stabilization of an arbitrary trajectory of a superconducting qubit by measurement-based feedback. The protocol benefits from the long coherence time () of the 3D transmon qubit, the high efficiency () of the phase-preserving Josephson amplifier, and fast electronics that ensure less than 500 ns total delay. At discrete time intervals, the state of the qubit is measured and corrected in case an error is detected. For Rabi oscillations, where the discrete measurements occur when the qubit is supposed to be in the measurement pointer states, we demonstrate an average fidelity of to the targeted trajectory. For Ramsey oscillations, which do not go through pointer states, the average fidelity reaches . Incidentally, we demonstrate a fast reset protocol that allows us to cool a 3D transmon qubit down to in the excited state.