This paper presents a simulation study of the impact of variation in temperature on transfer characteristics and RF/analog performance like transconductance (gm), gate capacitance (Cgg), cut off frequency (ft), transconductance frequency product (TFP) of Ferroelectric FinFET (Fe-FinFET). Also, the impact of temperature on linearity parameters such as higher order harmonics (gm2 and gm3), second and third order voltage intercept points (VIP2 and VIP3), third order power intercept point (IIP3), third order intermodulation distortion (IMD3), and 1-dB compression point are estimated for wide variation of temperature in Fe-FinFET. It is seen that temperature has significant impact on RF/analog and linearity parameters and these figure of merits (FoMs) are functions of temperature. Analysis reports that RF/analog parameters are suppressed, whereas, linearity FoMs are improved as temperature changed from 250 to 350 K.
7 February 2017 in IEEE Transactions on Electron Devices
This paper presents a 3-D statistical simulation study of an n-channel Si step-FinFET due to workfunction variability depending on grain orientation of metal gate. The statistical fluctuation induced by metal gate granularity on threshold-voltage(σ V T ), ON current (σI ON ), and OFF current (σI OFF ) are estimated for a wide range of channel length and effective fin width for varying average grain size using Technology Computer Aided Design simulator. We investigated the effect of grain on magnitude of variability and also on shapes of various electrical parameters of distribution. The results indicate that σ V T decreases for increase in each dimension of the device. The value of σI ON , and σI OFF reduces as channel length increases. However, σI ON and σI OFF increase as fin width increases. The distribution of electrical parameters is near to normal for small grain size and becomes bimodal at large grain size. The proposed structure shows excellent behavior in terms of threshold voltage (V T ), subthreshold swing, and current ratio (I ON /I OFF ) compared with conventional FinFET at high temperature. It is found that the hot carrier effect reduces with increased effective channel width.
The work analyses the significance of fringing capacitance in modelling effectively the amplitude of the ultrasonic waves generated by silicon nitride membrane‐based micromachined ultrasonic transducer (MUT). The amplitude of the ultrasonic waves is proportional to the displacement of the biased membrane under the influence of a sinusoidal signal. Fringing capacitance is significant as for operating the transducer in the medical imaging regime of frequency range 1–10 MHz, the dimension of the electrodes of the MUT capacitor becomes comparable with the separation between them. The device is modelled first without the fringing effect and then Palmer, Landau's and Younes Ataiiyan's approaches are considered for evaluating the fringing capacitance. The device is finite element method analysed by PZFLEX 3D simulator. The membrane displacement is evaluated with variation in device structural parameters of membrane radius and thickness, electrode separation and bias voltage for an extensive range of values. Fractional percentage error of the above analytical approaches is evaluated with respect to the PZFLEX which are regarded as closest to reality. Substantial decrease in the error is observed on modelling the device with the effect of the fringing capacitance.