26 January 2024 in IEEE Journal of Solid-State Circuits
This article introduces an efficient high-power radiator at 400 GHz and a fully integrated transceiver supporting OOK modulation for high-speed wireless communication using 90-nm SiGe BiCMOS. The reverse recovery of silicon p-i-n diodes is used to design a frequency quadrupler that generates high power efficiently at 400 GHz. By mutually interlocking and combining the power from two such quadruplers, we design a 400-GHz radiator. The proposed design achieves a peak effective isotropic radiated power (EIRP) of +20.6- and −5.8-dBm radiated power at 398 GHz with 0.2% dc-to-THz radiation efficiency. This is the highest reported efficiency, and THz power radiated per element above 320 GHz. Using the p-i-n diode quadruplers as the LO, we design a 400-GHz OOK transmitter and receiver with on-chip antennas. The transmitter uses a multiplier-last approach and has an EIRP of +17 dBm while consuming 84-mW dc power. The receiver uses fundamental-driven passive mixer architecture to achieve a noise figure (NF) of 25 dB while consuming 184 mW of dc power. This is the lowest reported NF above 320 GHz. Over-the-air (OTA) measurements are performed for a 5-cm link with OOK modulation. The stand-alone transmitter supports a data rate of 10 Gb/s (8 pJ/bit), and the transmit–receive system supports a data rate of 5 Gb/s (36.8 pJ/bit for the receiver). This is the first demonstration of a fully integrated multi-Gb/s wireless transceiver above 320 GHz in silicon.
6 January 2025 in IEEE Transactions on Microwave Theory and Techniques
This article presents a fully integrated multimode orbital angular momentum (OAM) transmitter using a circular slot cavity antenna, capable of concurrently operating three orthogonal OAM modes ( $|l_{\text{oam}}|$ $=$ 0, 1, and 2) while maintaining a common phase center. This allows the use of passive gain elements like lenses or reflectors for directivity enhancement. Additionally, the transmitter takes advantage of high-order cavity modes eliminating the complex multiphase feeding network. Detailed studies about the angular momentum (AM) of the radiated electromagnetic (EM) wave and the correlation between the antenna mode and OAM/SAM mode are provided in this article. The single-element transmitter is composed of a 120-GHz oscillator and a p-i-n diode frequency tripler interfacing with harmonic filtering networks. The transmitter can generate OAM waves at 360-GHz signal with a peak radiated power of $-$ 8.1 dBm and a dc-to-THz efficiency of 0.1%. It also exhibits a wide-frequency tuning range of 14.2%. The chip is fabricated in the GlobalFoundries 90-nm BiCMOS process. Apart from transmitter design, this work also introduces a method for measuring OAM amplitude and phase distribution that does not require Tx/Rx frequency and phase coherency, simplifying the measurement process and ensuring accurate characterization of OAM modes. Its ability to operate in multiple OAM modes simultaneously, combined with its compact and efficient design, highlights its potential for future secure high-capacity communication applications.
21 February 2025 in IEEE Microwave and Wireless Technology Letters
This letter presents a continuous-wave (CW) radar for micrometer-level phase and vibration detection based on super-harmonic self-injection locking in a free-running oscillator. The radar system consists of an oscillator that radiates a signal which gets reflected off a target. The reflected signal is re-injected into the oscillator. Due to super-harmoinc self-injection-locked (SSIL), this causes a frequency shift dependent on the target distance, enabling precise ranging. The proposed radar is implemented using a 140 GHz oscillator followed by an efficient medium-breakdown HBT-based doubler and on-chip antenna. The doubler achieves a peak EIRP of +25.3 and -0.1 dBm radiated power at 281 GHz and consumes 144 mW dc power (dc-to-THz efficiency of 0.68%). In SSIL radar operation, a frequency shift of 250 MHz is observed. Using the proposed radar, we demonstrate: 1) detection of sub-30 μm vibrations and 2) reflection-based phase imaging.
16 January 2026 in IEEE Transactions on Microwave Theory and Techniques
This article presents a novel complementary self-injection-locked (CSIL) radar architecture for low-power, high-accuracy THz phase sensing. Unlike conventional phase-sensing radars, the CSIL technique does not require frequency synthesis, enabling a compact architecture with low power consumption. It consists of a coupled oscillator pair with envelope detectors for sensing the oscillation amplitude. The oscillator is connected to a novel on-chip hybrid-mode dual-polarized slot antenna for radiation. The CSIL radar employs the self-injection locking (SIL) technique, where a portion of the transmitted signal reflects off the target and is reinjected into the radar. Due to the coupled nature of the system, this self-injection process induces an amplitude imbalance between the oscillators as a function of the target distance. By measuring this amplitude imbalance using the envelope detectors, the system can estimate relative displacements within an unambiguous range of $\lambda $ /4. The CSIL architecture is inherently immune to self-interference. It also features an autodyne design, with a single-phase center, allowing easy integration with external optics such as lenses or mirrors. The proposed radar is fabricated using the TSMC 65-nm process. Operating at 232 GHz, it achieves a static range accuracy of $20~\mu $ m while consuming only 4.6 mW of dc power. The architecture also supports 3-D imaging, demonstrated through preliminary imaging experiments. These results establish CSIL as a promising solution for compact, energy-efficient mm-wave and THz sensors in precision sensing and imaging applications.
1 January 2026 in IEEE Transactions on Antennas and Propagation