9 February 2024 in IEEE Transactions on Vehicular Technology
The enhancement of vehicle passenger safety is a central theme for car manufacturers. Since the introduction of Electronic Stability Control (ESC) in the late 90s, researchers in industry and academia have kept striving for continuously enhancing vehicle safety. However, despite significant efforts, the literature shows that a significant number of these endeavors have not advanced beyond theoretical formulations and software simulations. This paper presents the testing journey of an individual-wheel-torque-based vehicle stability controller through the major milestones of its development cycle. First, the controller is formulated based on specific vehicle dynamics design requirements. Then, an offline co-simulation is put in place to validate the controller along relevant maneuvers, with the controller running on Matlab-Simulink concurrently with the software Amesim running a 15-dof vehicle model of Siemens' SimRod battery electric vehicle. Next, a real-time co-simulation is achieved, running both the controller and the vehicle model on a real-time platform. Finally, an experimental hardware-in-the-loop setup is built, incorporating a dedicated Electronic Control Unit (ECU), and successfully tested.
14 April 2020 in SAE International Journal of Advances and Current Practices in Mobility
A rapidly shifting market and increasingly stringent environmental regulations require the automotive industry to produce more efficient low-emission Electric Vehicles (EVs). Regenerative braking has proven to be a major contributor to both objectives, enabling the charging of the batteries during braking and a reduction of the load and wear of the brake pads. The optimal sizing of such systems requires the availability of good simulation models to improve their performance and reliability at all stages of the vehicle design. This enables the designer to study both the integration of the braking system with the full vehicle equipment and the interactions between electrical and mechanical braking strategies. This paper presents a generic simulation framework for the identification of thermal and wear behaviour of a mechanical braking system, based on a lumped parameter approach. The thermal behaviour of the system is coupled back to the friction coefficient between the pad and the disk to assess its effect on braking performance. Additionally, the effect of wear and temperature on the generation of airborne particles is investigated. Subsequently, experimental data collected on a real EV is used to validate and tune the previously described simulation model, following a proposed validation procedure. The instrumentation method and challenges, as well as the experimental procedure used to collect the data on a chassis dynamometer and in real-world driving conditions, are described. Finally, simulation results for different driving scenarios are used to compare virtual and experimental results.