1 April 2011 in Agriculture, Ecosystems & Environment
1 July 2016 in Solar Energy
1 December 2014 in Journal of Horticultural Research
Leafy vegetables are the source of many valuable components like vitamins, minerals and phenolic compounds as antioxidants. Chlorophyll derivatives have antioxidant and anticarcinogenic activity, or may even act as signalling molecules in organisms. However, during the storage of the leafy vegetables in the cold and darkness, numerous biochemical changes usually occurs, demonstrated as the breakdown of chlorophyll. Storage ability of plants depends to some extent on the conditions under which plants grew. Lamb’s lettuce plants were grown in the greenhouse in different light regimes - emitted with sodium (HPS-control) and LED lamps (100% red, 90% red + 10% blue, 70% red + 30% blue and 50% red + 50% blue light). The intensity of radiation at the height of the leaves of the plants was the same in every treatment. After harvesting, the plants were stored at the temperature of 5 °C and high humidity in plastic bags. The analyses of the material were done four times: after harvest and three times during storage at weekly intervals. Fresh weight lost, dry matter, phenolics and chlorophyll content were analysed. Additionally, the fluorescence of chlorophyll a was carried out. Changes in plant fresh weight and dry matter content during storage did not depend on the lighting used during cultivation. After 3 weeks of storage, higher value of indicator of the vitality of PSII (PIABS - Performance Index) was noticed in leaves treated with higher red light intensity during cultivation (100%, 90% and 70% red). LED lamps, which emitted 100% and 90% red light, enhanced concentration of total phenolics in lamb’s lettuce leaves. Light of HPS lamps decreased radical scavenging activity in leaves. Quality and usefulness of plants produced under LED lamps was just as good as those grown under HPS lamps.
1 February 2016 in Circuit World
Purpose: – This paper aims to present certain issues in direct bonded copper (DBC) technology towards the manufacture of Al2O3 or AlN ceramic substrates with one or both sides clad with a copper (Cu) layer. Design/methodology/approach: – As part of the experimental work, attempts were made to produce patterns printed onto DBC substrates based on four substantially different technologies: precise cutting with a diamond saw, photolithography, the use of a milling cutter (LPKF ProtoMat 93s) and laser ablation with differential chemical etching of the Cu layer. Findings: – The use of photolithography and etching technology in the case of boards clad with a 0.2-mm-thick Cu layer, can produce conductive paths with a width of 0.4 mm while maintaining a distance of 0.4 mm between the paths, and in the case of boards clad with a 0.3-mm-thick copper layer, conductive paths with a width of 0.5 mm while maintaining a distance of 0.5 mm between paths. The application of laser ablation at the final step of removing the unnecessary copper layer, can radically increase the resolution of printed pattern even to 0.1/0.1 mm. The quality of the printed pattern is also much better. Research limitations/implications: – Etching process optimization and the development of the fundamentals of technology and design of power electronic systems based on DBC substrates should be done in the future. A limiting factor for further research and its implementation may be the relatively high price of DBC substrates in comparison with typical PCB printed circuits. Practical implications: – Several examples of practical implementations using DBC technology are presented, such as full- and half-bridge connections, full-wave rectifier with an output voltage of 48 V and an output current of 50 A, and part of a battery discharger controller and light-emitting diode illuminator soldered to a copper heat sink. Originality/value: – The paper presents a comparison of different technologies used for the realization of precise patterns on DBC substrates. The combination of etching and laser ablation technologies radically improves the quality of DBC-printed patterns.