21 September 2020 in IEEE Communications Letters
In this letter, we present the first study for uplink cell-free massive multi-input multi-output (MIMO) systems with superimposed pilots (SPs). Closed-form linear minimum mean square error (LMMSE) channel estimation and achievable spectral efficiency (SE) expressions with maximal ratio combining (MRC) receiver filters are derived. The tractability of the closedform results facilitates analyzing the effects of key design system parameters, such as the number of mobile terminals (MTs), the power balance factor between pilot and data symbols, and the length of coherence interval. Several significant insights are attained by assuming that the introduced pilot interference can or cannot be perfectly canceled from received data symbols. All the theoretical results are corroborated by simulation experiments.
28 February 2020 in IEEE Access
In this paper, we present the detailed rate analysis for cell-free massive multiple-input multiple-output (MIMO) systems over spatially correlated Rayleigh fading channels. Taking the realistic impairment effects of spatial channel correlation, pilot contamination, and channel estimation errors into account, the lower-bounds of the achievable rates for both the uplink and downlink are derived with the low-complexity linear processing such as matched filter and conjugate beamforming, which enable us to take cognizance of the impacts of transmitted power, and the number of access points (APs). Based on the derived rate results, the asymptotic performance analysis is then carried out. Besides, we propose the sophisticated max-min power allocation strategies taking the actual requirements into consideration to provide uniformly good service to all users. However, the objective functions of the two optimization problems are both non-concave. Fortunately, the former for uplink can be characterized as geometric programming (GP), whilst the latter for downlink merging the efficient tools of second-order-cone programming (SOCP). Lastly, the numerical results are shown to verify our analytical results and the effectiveness of the proposed max-min fairness algorithms.
16 June 2020 in IEEE Access
In millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems, the hybrid beamforming architecture has been put forward to reduce the high hardware cost and power consumption, which are resulted from the tremendous requirements of dedicated radio frequency (RF) chains. In this paper, we propose several strategies to design analog and digital precoders for a point-to-point (P2P) hybrid MIMO system. Aiming at minimizing the Euclidean distance between the optimal digital precoder and hybrid precoder, we decouple this matrix factorization problem into a nonconvex quadratically constrained quadratic programming (QCQP) problem and an unit-modulus least-squares (ULS) problem, which can be solved by the presented three alternating optimization algorithms. Simulation and analysis results indicate that the proposed semidefinite relaxation based alternating optimization (SDR–AO) algorithm can approach near-optimal spectral efficiency performance compared with previous algorithms in the literature, but shows extremely high computational complexity. The alternating direction method of multipliers based alternating optimization (ADMM–AO) algorithm is preferred in the case that the number of transmit antennas is much larger than that of receive antennas or the amount of data streams is small. Moreover, when equal number of RF chains and data streams are employed, the analytical constant modulus factorization based alternating optimization (ACMF–AO) algorithm is a better choice. Finally, the proposed algorithms can also be well applied in finite resolution phase shifters (PSs) of the analog component and are extended to wideband mmWave systems.
11 August 2021 in IEEE Systems Journal
Device-to-device (D2D) communication coexisted with a cell-free massive multiple-input multiple-output (MIMO) system will be one of the pieces of the B5G/6G jigsaw puzzle. In this article, a D2D underlaid cell-free massive MIMO system with low-resolution digital-to-analog converters is studied, where multiantenna D2D user equipments (DUEs) communicate pairwise with each other in the same time-frequency resources as cell-free with equipments (CFUEs). Assuming imperfect channel state information is available at access points (APs), the downlink closed-form achievable rates for both CFUEs and multiantenna DUEs are derived, which enable us to give insights into the impacts of the key design parameters (e.g., the AP number, the DUE density, and its antenna number) on achievable rate. After that, a power control scheme is developed to maximize the average sum rate of CFUEs and DUEs, and we show that the proposed power control problem can be effectively solved by using the path-following algorithm. Finally, numerical simulations are provided to highlight the system performance and verify the effectiveness of the proposed algorithm.
28 March 2024 in IEEE Transactions on Vehicular Technology
The reconfigurable intelligent surface (RIS) is considered a promising technique to improve the performance of user equipments in service dead zones in cell-free massive multipleinput multiple-output (CFmMIMO) systems. In this paper, we investigate the impact of channel aging on the uplink CFm- MIMO system aided by RISs with spatially correlated elements. We derive the closed-form expression of the uplink achievable spectral efficiency (SE) with the matched-filter receiver under channel spatial correlation and channel aging. Assuming only the statistical channel state information, we propose a two-step optimization scheme including the RIS phase shift design and power allocation. We first formulate the maximum normalized mean-squared error minimization problem to design the RIS phase shift in uplink training and solve it using the successive convex approximation algorithm. Then, we solve the sum SE maximization problem in the uplink data transmission to accomplish the power allocation by using the Lagrangian dual reformulation and the fractional programming theory. Extensive numerical results demonstrate the effectiveness and convergence of the proposed two-step optimization scheme.
2 June 2021 in IEEE Systems Journal
In this article, the effects of multiantenna users and low-resolution analog-to-digital converters/digital-to-analog converters (ADCs/DACs) on multigroup multicast downlink cell-free massive multi-input multi-output (MIMO) systems are explored. Leveraging on the distributed conjugate beamforming receiver and the generalized additive quantization noise model, we first derive a closed-form expression for the achievable sum spectral efficiency (SE). The resultant expression enables us to precisely quantify the effects of key parameters, such as the transmit power of access points (APs), the numbers of groups, users’ antennas, APs’ antennas, and quantization bits. Due to the joint influence of channel hardening property, multiantenna gain, and intergroup interference, the research becomes sophisticated particularly. The result shows that when the sum-SE is small, the multicast is better than the unicast and vice versa. Typically, it reveals that the full-resolution DAC can be replaced by 5-bit low-resolution DAC to achieve the same performance, and the additional antenna at users can effectively enhance the system performance. Then, according to a generated energy cost model, the formula of the energy efficiency (EE) is obtained. When the DAC quantization is equal to 2-bit, it can achieve the maximum sum EE. Finally, the simulation results are provided to verify the derived results.