Computer aided design and simulations are an integral part in the development process of integrated circuits. In order to evaluate the electromagnetic compatibility (EMC) of integrated circuits in simulation, simulation models of the EMC measurement setup and the EMC measurement device are needed. In this work, an electromagnetic interference (EMI) receiver simulation model is presented. The EMI-reciever simulation model is intended to analyze electromagnetic emission (EME) of integrated circuits from transient simulations. The model is explained in detail and emulates an CISPR-16 conform test receiver. It is implemented using an STFT algorithm, and evaluates simulation output in CISPR Band-B/C/D with peak, average and quasi-peak detector. A quasi-peak detector model for pulsed disturbances is described, that significantly reduces simulation time compared to traditional implementations. The presented EMI-receiver model is verified with different test setups.
15 January 2016 in e+i Elektrotechnik und Informationstechnik
Due to their high efficiency compared to conventional Class AB amplifiers, Class D audio amplifiers have increasingly become the amplifier of choice especially for low power applications such as portable electronics. However, Class D amplifiers are still a major source of electromagnetic emission of the electronic applications in which they are used. In this paper the benefits of using spread spectrum techniques in order to reduce the emission of Class D audio amplifiers is highlighted. Based on IC-level measurement results of a 10W Mono Class D speaker amplifier, that allows to be synchronized to an external clock, it is shown how spread spectrum parameters like deviation, modulation frequency and modulation signal can be optimized in order to maximize the reduction of the emission.
Class-D audio amplifiers may significantly contribute to the electromagnetic emissions of electronic devices. This work deals with the electromagnetic emissions created by Class-D amplifier output stages. Output stage switching schemes of traditional and filterless Class-D amplifiers are analyzed concerning their ability to create electromagnetic disturbances. Three different switching schemes are compared, namely Class-AD, Class-BD, and Ternary switching. Finally, commercially available Class-D amplifier ICs are measured and compared using an electromagnetic compatibility measurement setup according to IEC61967-4-A1.
In this paper the ability of using spread spectrum clock generation (SSCG) techniques for audio applications is investigated. It is shown how this technique can be used to reduce the electromagnetic emission that is caused by the high frequency switching activity of Class-D audio amplifiers. Additionally the trade-offs when using this technique are explained. Based on measurement and simulation of the conducted common-mode electromagnetic emission and THD+N of a class D audio amplifier, it is shown how the spread spectrum technique can be used to reduce the electromagnetic emission in certain frequency ranges and how it impacts the audio performance.