6 October 2022 in ACS Omega
The possibility of inducing magnetization in tungsten selenide monolayer by alloying with vanadium selenide was investigated through first-principles calculations. Electronic, optical, and magnetic properties of different W1-x V x Se2 alloy compositions were studied extensively. As the proportion of vanadium atoms in the alloys increased, a phase transition from semiconducting to metallic to semiconducting was discovered. All alloy compositions demonstrated induced magnetism with a long-range ferromagnetic order. Interestingly, in the case of the W0.25V0.75Se2 alloy, spin-up states in the band diagram showed a finite band gap, while a nonzero band gap was found for spin-down states. The W0.25V0.75Se2 alloy can be used as a spin filter tunneling barrier exploiting this fascinating property. High spin polarization of the tunnel current was found for the alloy. Furthermore, under the Curie temperature, electrical conductivity for the spin-up channel was found to be zero, while conductivity for the spin-down channel was around 1019 (Ω cm s)-1 when the chemical potential was 0.2 eV greater than the Fermi energy. Changes in optical properties were also investigated through time-dependent density functional theory calculations. The findings of this study will be beneficial for proposing new magnetic monolayer alloys for application in nanoscale spintronic devices.
19 December 2022 in Catalysis Science & Technology
We proposed a novel scheme for achieving enhanced photocatalytic activity in two-dimensional nanomaterials. Traditionally, substitution doping and employing van der Waals heterostructures have been popular methods for enhancing photocatalytic activity. We demonstrated here, using ab initio calculations, that halogen functionalization could be an excellent scheme for enhancing photocatalytic activity in AlSb monolayers. Bromine and iodine functionalized AlSb monolayers were energetically and dynamically stable and had excellent band alignments that can facilitate photocatalytic water splitting for hydrogen production. The calculation of Gibbs free energy along the photocatalytic pathway revealed that there is only a very low barrier for hydrogen or oxygen evolution reactions. The solar-to-hydrogen efficiency reached ∼30%, with a carrier utilization efficiency reaching 40%. Our findings open a new avenue for research employing photocatalysis to generate green energy.
6 February 2025 in ACS Applied Materials & Interfaces
Transition metal dichalcogenides (TMDs) are an important class of materials for future microelectronics. Of particular interest are TMDs deposited by atomic layer deposition (ALD) since this technique allows both back-end-of-line (BEOL) compatible deposition and the ability to create heavily doped regions for contact formation. In this work, we characterize ∼3 nm-thick heavily doped NbxW1-xSy thin films grown by plasma-enhanced ALD using gated transfer-length measurement (TLM) structures. An analysis of films with different Nb concentrations, x, found that films with x = 0.22 had the lowest sheet resistivity of 86 kΩ/sq along with an ultrahigh carrier concentration of 4.2 × 1020 cm-3. The contact resistance, RC, of different metals to NbxW1-xSy thin films was also analyzed. Among Pd, Ni, and Ti contacts, Pd was found to have the lowest RC, whereas Ni (Ti) had an average RC that was 6× (20×) higher than Pd. Physical analysis of the films using Raman spectroscopy and transmission electron microscopy shows that the crystal quality degrades going from x = 0.08 to 0.33, while Kelvin probe force microscopy, complemented by density functional theory, is used to explain the Nb concentration of the extracted work function. The best TLM structures have an RC value as low as 0.30 ± 0.26 kΩ-μm and a mean specific contact resistivity, ρC, of 11 ± 27 nΩ-cm2. Even after accounting for experimental error, this value is lower than the other values reported for p-type TMD contacts in the literature. These results suggest that NbxW1-xSy can be a promising intermediate layer between metal contacts and monolayer WSe2 in future scaled-down TMD MOSFETs.
2 June 2026 in ACS Applied Materials & Interfaces