Imec has developed a new technology to integrate and interconnect back-contact solar cells into modules, based on embedding cells in silicone on top of a glass substrate. This technology aims at an improved optical performance and reliability (through the use of silicones and low-temperature metallization). One of the additional advantages is that the technology is suitable for integrating very thin cells into modules: whereas standalone interconnection of such fragile thin cells, e.g. tabbing and stringing, would significantly lower the throughput yield due to breakage, the cells are better protected if they are embedded inside silicone. The paper will first elaborate on the process flow, the background and motivation, advantages, drawbacks and limitations, and technical aspects of the developed technology. Then it will present the results of the measurements on the performance of functional solar cells processed into modules using this technology, discussing losses and loss mechanisms. Then, the approach towards determining the reliability of the module will be presented, indicating how imec aims at building up an ageing model, and elaborating the results on the failure mode and effect analysis, modeling, characterization and reliability testing.
In this work, two mini-modules using a 3D multi-ribbon interconnection are fabricated. One with TPO and the other with glass fiber reinforced TPO (GF TPO) encapsulant. Using fiber Braggs grating sensors (FBGS) attached to the cell, in situ temperature and strain are quantified during reliability tests in the form of thermal cycling from -40°C to +85°C. It was found that the temperature of the cell surface reaches -36°C and +81°C at its minimum and maximum respectively. The measured cell strain followed the same cycling behavior between tension and compression. The strain in the GF TPO based module was found to have a lower peak-to-peak (difference between max tension and compression) value. Also, a consistent difference between strain in parallel and perpendicular directions relative to the busbars was observed, with the latter one being larger.