This article presents the results of the synthesis of carbon nanomaterials: Nanoscale materials obtained by carbonization of waste agricultural products (apricot kernel, walnut, rice husk). The results of physico-chemical characteristics of the obtained nanomaterials.
This article presents the results of the synthesis of carbon nanomaterials: Nanoscale materials obtained by carbonization of waste agricultural products (apricot kernel, Greek walnut (GW), rice husk). The results of physico-chemical characteristics of the obtained nanomaterials. Physico-chemical parameters of the synthesis of carbonized sorbents based on plant raw material are investigated along with the properties of these sorbents. The data of FTIR, ESR spectroscopy & BET-method, as well as electron microscopy are reported. It is stated that carbonized sorbents possess high specific surface area and porosity. Carboxylic, carbonyl, hydroxyl groups are detected on the surface of the synthesized sorbents. Separate fusicoccine and similar biostimulators effectively; remove LPS-endotoxines from blood plasma selectively. They may be used as carriers to introduce probiotics into intestine thanks to formation of stable colonies on their developed surface. A method of preparation of honeycomb monoliths from carbonized rice husk with developed mesoporous structure via modification of the porous structure by silica leaching has been developed.
30 May 2018 in Eurasian Chemico-Technological Journal
Activated carbons (ACs) have been prepared from chemical treatment of walnut shells (WS) precursor at various temperatures (400‒800 °C) by using phosphoric acid (H3PO4) as activating agent. Influence of activation temperature on the porosity development and capacitive properties of resulting carbons was investigated. Thermal post-treatment of carbons previously activated at moderate temperature, e.g. 400 °C allowed further structural and porosity modification. Then, these carbons were investigated by scanning electron microscopy, Raman spectroscopy, energydispersive X-ray spectroscopy, electrochemical techniques and low temperature nitrogen adsorption exhibiting high BET specific surface area of approximately 2100 m2 g-1 and a total pore volume up to 1.3 cm3 g-1. Carbon material obtained through activation by H3PO4 at 400 °C and post-treated at 800 °C was used to make electrodes which were implemented to realize AC/AC capacitor using 1 mol L-1 Li2SO4. The electrochemical capacitor demonstrated high capacitance of 123 F g-1 per mass of one electrode, reduced cell resistance and stable capacitance for 5000 galvanostatic charge/discharge cycles at 1.0 A g-1.