The quantification of the interfacial area between fluids in a multiphase system in porous media has been a subject of growing interest in disciplines where mass transfer across fluid interfaces is of importance. In this study, a proof of concept for a novel kinetic interface sensitive (KIS) tracer is provided by employing a simple, low‐cost, well‐controlled dynamic column experiment in conjunction with a macroscale two‐phase flow reactive transport model. The steel column is filled with a well‐characterized porous medium consisting of well‐sorted normally distributed glass beads (d50 = 240 μm). KIS tracers were designed to determine the specific interfacial area, awn, between a nonwetting fluid and a wetting fluid, by evaluating the chemical reaction rates and mass transfer across the fluid‐fluid interface. This study shows for the first time a general framework behind the use of KIS tracers and their potential in assessing the awn for a known capillary pressure‐saturation relationship under laboratory conditions. A two‐phase flow four‐component reactive transport and a two‐phase flow two‐component transport numerical model were developed to simulate the oil flooding of the initially water saturated column and tracer breakthrough curves obtained from experimental data. These breakthrough curves were subsequently used to approximate awn using a polynomial relationship. The interpretation of the KIS tracer column experiments indicates that the range for maximum value of awn is between 500 and 540 m2/m3. The results also show that despite the use of two independently synthesized tracers, if the reaction kinetics are well quantified, similar awn values can be obtained.
Pore pressure prediction is a well-developed key discipline for well planning in the hydrocarbon industry, suggesting a similar importance for deep geothermal wells, especially, since drilling cost is often the largest investment in deep geothermal energy projects. To address the role of pore pressure prediction in deep geothermal energy, we investigated pore pressure-related drilling problems in the overpressured North Alpine Foreland Basin in SE Germany – one of Europe's most extensively explored deep geothermal energy plays. In the past, pore pressure was mainly predicted via maximum drilling mud weights of offset hydrocarbon wells, but recently more data became available, which led to a re-evaluation of the pore pressure distribution in this area. To compare the impact of pore pressure and its prediction, 70% of all deep geothermal wells drilled have been investigated for pore pressure-related drilling problems and two deep geothermal projects are given as more detailed examples. Thereby, pore pressure-related drilling problems were encountered in one third of all wells drilled, resulting in several side-tracks and an estimated drilling rate decrease of up to 40%, highlighting the importance of accurate pore pressure prediction to significantly reduce the cost of deep geothermal drilling in overpressured environments. Thematic collection: This article is part of the Geopressure collection available at: https://www.lyellcollection.org/cc/geopressure