Seungchan Lee

Seungchan Lee

Auto-generated profile, based on publicly available information

Seungchan Lee

Department of Intelligent Electronics and Computer Engineering, Chonnam National University, Gwangju, South Korea

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 January 2019 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
SLSeungchan Lee
Seungchan Lee
JPJinseok Park
Jinseok Park
SHSongcheol Hong
Songcheol Hong

1 November 2022 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
JPJinseok Park
Jinseok Park
SLSeungchan Lee
Seungchan Lee
JCJonghoon Chun
Jonghoon Chun
LJLaurence Jeon
Laurence Jeon
SHSongcheol Hong
Songcheol Hong
A 28-GHz fully differential four-channel beamforming front-end IC with variable gain phase shifters (VGPSs) is presented, of which orthogonal phase and gain control is achieved in a single block using the proposed dual-vector synthesis technique. This greatly reduces chip size, power consumption, and calibration complexity. The antenna switch embedded in the front-end matching network minimizes degradation of the transmitter (TX) efficiency and receiver (RX) noise figure. The multi-mode power amplifier (PA) with a built-in linearizer is presented to have high efficiency and linearity for all power modes, which reduces power consumption during gain control. Also, a differential four-way power divider and an single pole double throw (SPDT) switch are introduced in the common path, which has a small chip size and a low insertion loss. By adopting differential structures for all components in the four-channel IC, the effect of parasitic grounding inductances due to bonding and package is minimized. Thanks to the proposed dual-vector VGPS, the rms gain error of 0.21 dB and the peak phase variation of ±1.7° are achieved during phase control and gain control, respectively, without any calibration. The four-channel front-end IC also achieves rms phase error of only 1.4° during the simultaneous phase and gain control without any calibration. It has a TX OP1dB of 13.3 dBm and the highest linear output power of 7.2 dBm with 400-MHz 64-QAM fifth-generation (5G) new radio (NR) signals with 9.6-dB peak-to-average power ratio (PAPR). Also, this article presents a 64-element brick-type phased array antenna using four-channel core chips. It shows a high effective isotropic radiated power (EIRP) of 54.4 dBm at 28 GHz. An over-the-air link is demonstrated with a competitive data rate of 4 Gb/s using 64-QAM waveforms over all scan angles at a distance of 100 m.

26 August 2021 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
SLSeungchan Lee
Seungchan Lee
JPJinseok Park
Jinseok Park
SHSongcheol Hong
Songcheol Hong
A differential four-way power divider for 24 to 30 GHz and a frequency reconfigurable differential four-way power divider for 24 to 30 GHz and 37 to 43.5 GHz are presented. The differential structure provides sound virtual grounds in a multiple-channel chip. Both circuits have a four-way Wilkinson power divider (WPD) configuration based on lumped elements that provide small chip sizes. The first one has a small core chip area of 0.09 mm 2 , a small insertion loss of 0.93 to 1.94 dB, and the port-to-port isolation of 19.1 to 25.6 dB from 24 to 30 GHz. It has a small amplitude and phase differences at four outputs. The second one allows frequency-reconfigurable operation by switching inductances and capacitances to cover widely separated frequency bands (5G NR n257-n261 bands). In addition, switched capacitors (SCs) are inserted to resonate out the parasitic series inductances in isolation resistors at both bands of 24–30 GHz and 37–43.5 GHz. It has a core chip area of 0.168 mm 2 , insertion losses of 1.65–1.89 dB at 24 to 30 GHz and 2.04–2.70 dB at 37 to 43.5 GHz, respectively. The port-to-port isolations are 23.4–37.6 dB at 24 to 30 GHz and 22.6–28.4 dB at 37 to 43.5 GHz.

13 September 2022 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
JPJinseok Park
Jinseok Park
SLSeungchan Lee
Seungchan Lee
SHSongcheol Hong
Songcheol Hong
A 24–40 GHz CMOS differential SPDT switch that covers multiple frequency bands of millimeter-wave 5G communication is presented. The switch has a differential structure in which NMOS and PMOS are alternately connected, and leakage-canceling capacitors are cross-connected the two outputs of the switch. The differential structure allows it to have parasitic ground inductance robust characteristics. The opposite ON/OFF characteristics of NMOS and PMOS allow the gates of off-state NMOS/PMOS transistors to have lower/higher voltages than their source and drain without using DC block capacitors, improving both the power handling capability and the insertion loss. In the proposed SPDT structure, the resistors for source and drain biasing are eliminated, which resolves the trade-off between the ON/OFF time and the insertion loss. In addition, cross-connected capacitors in the differential structure are readily used as a leakage canceller, offering a high level of isolation at all frequency bands. The switch is implemented in a 65-nm RF CMOS process with a core area of only 0.016 mm2. Owing to the simple alternating structure, insertion losses lower than 1.6 dB and IP1dB higher than 24 dBm are achieved from 24 to 40 GHz. In addition, the isolation is improved by around 15 dB due to the proposed leakage-canceling capacitors. The measured isolation is higher than 30 dB from DC to 50 GHz.

2 January 2023 in IEEE Microwave and Wireless Technology Letters
Verified
Journal Article
Closed access
SLSeungchan Lee
Seungchan Lee
SHSongcheol Hong
Songcheol Hong
A differential low-noise amplifier (LNA) for the 5G n257 band and a frequency reconfigurable differential LNA for both the 5G n257 and n260 bands (26.5–29.5 and 37–40 GHz), fabricated in a 65-nm CMOS process, are presented. Both LNAs achieve better gain and noise figure performances due to the use of magnetically coupled gm-boosting in the common-gate stage of a cascode amplifier. Furthermore, the frequency-reconfigurable LNA uses frequency reconfigurable matching circuits at the input, interstage, and output to achieve optimal noise and gain matchings for each band. The single band LNA has a core chip area of 0.11 mm $^\text{\text{2}}$ , a peak gain of 11.9 dB, a 3-dB bandwidth of 5.3 GHz, and a noise figure of 2.79 dB at 28.5 GHz. The dual-band LNA is capable of dual-band operation due to the reconfiguring matching circuits with switched coupled inductors (SCIs) and switched capacitors. It has a core chip area of 0.12 mm $^\text{\text{2}}$ , peak gains of 11.1/8.5 dB, 3-dB bandwidths of 4.8/9.4 GHz, and minimum noise figures of 3.49/4.01 dB at 28.5/38 GHz, respectively.

10 April 2024 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
SKSuyeon Kim
Suyeon Kim
DKDong Young Kim
Dong Young Kim
JPJe Won Park
Je Won Park
SKShinwook Kim
Shinwook Kim
SLSeungchan Lee
Seungchan Lee
MLMyoung Jin Lee
Myoung Jin Lee
As dynamic random access memory (DRAM) technologies continue to be downscaled, the partial isolation type buried channel array transistor (Pi-BCAT) structure has emerged as an innovative solution for the increasing challenges caused by leakage current adjacent to passing word lines (PWLs). This study reveals that the Pi-BCAT reduces leakage currents by 30% when compared to conventional BCAT structures. Our comprehensive simulations demonstrate that Pi-BCAT is resistant to temperature-induced leakage variations, confirming its significance in promoting consistent device performance and power management. The Pi-BCAT structure is predicted to be crucial in the advancement of DRAM reliability and efficiency, hence initiating further advancements in semiconductor technology.