30 November 2012 in Journal of Micromechanics and Microengineering
14 February 2011 in Journal of Microelectromechanical Systems
In this paper, polymer-based flat heat pipes (PFHPs) with a thickness on the order of 1 mm have been successfully developed and tested. Liquid-crystal polymer (LCP) films with copper-filled thermal vias are employed as the case material. A copper micropillar/woven mesh hybrid wicking structure was designed and fabricated to promote evaporation/condensation heat transfer and the liquid supply to the evaporator of the PFHP. Water was selected as the working fluid because of its superior thermophysical properties. An experimental study was conducted to examine the PFHP performance. The test data demonstrated that the PFHP can operate with a heat flux of 11.94 W/cm2 and results in effective thermal conductivity ranging from 650 to 830 W/m · K, with the value varying with the input heat flux and the tilt angle. With the employment of flexible LCP as casing material, the PFHP could potentially be directly integrated into a printed circuit board or flexible circuits for thermal management of heat-generating components.
1 May 2018 in Applied Energy
20 March 2012 in Journal of Micromechanics and Microengineering
1 January 2015 in Physics Procedia
GPGuylaine Poulin-Vittrant
+1
Using vertically grown hydrothermal ZnO nanowires, we demonstrate the assembly of fully functional piezoelectric energy harvesters on plastics substrates. A seedless hydrothermal process is employed for the growth of single crystalline vertically orientated ZnO NWs at around 100oC. Flexible NG are assembled using ∼7μm thick PDMS polymer matrix on a 3x3cm substrate. A representative device with an active area of 4cm2 is characterised revealing average output voltage generation of ∼22mV (±1.2) and -32mV (±0.16) in the positive and negative cycles after 3-4mm periodic deflection at 20Hz. A power density of ∼288nW/cm3 is estimated for the device. It is envisaged that such energy scavengers may find potential applications targeting self-powered systems, sensors and on-body charging of electronics
1 January 2015 in Physics Procedia
The present work investigates the possibility to charge a Lithium micro-battery (LiB) via direct conversion of ambient mechanical energy into electricity using piezoelectric ZnO nanowire (NW) based microgenerators (PGs). An estimate is provided for the power levels at the different stages of mechanical-to-electrical energy conversion chain, in the following areas: (1) PG output, (2) power management block and (3) LiB storage unit. Also covered in this work is the synthesis, which is a prerequisite for realising such PGs. ZnO NWs of 2μm in length and 200nm in diameter have been grown using a low temperature (<150°C) hydrothermal process on 100μm thick PET substrates (25 × 25 mm2). Substrates containing bi-layer metal layers with dissimilar electro-negativities functioned as a galvanic cell in the growth nutrients, which acted as an electrolyte medium. This necessitated ZnO NWs growth on conductive surfaces, even in the absence of seed layers and/or substrate with specific lattice parameters. Finally, the assembly steps undertaken to realise the fully functional PGs are discussed, and the performances of the final PG are described thereafter. Subjecting such devices to a 10Hz sinusoidal bending force resulted in a measured PG output of ∼56mV peak to peak, on 1 MΩ resistive load