Two‐step‐absorption 3D laser nanoprinting allows for using compact and low‐cost continuous‐wave (cw) lasers. Therefore, it is an attractive alternative to established state‐of‐the‐art multi‐photon‐absorption 3D laser nanoprinting. Additionally, low single‐focus polymerization‐threshold laser powers pave the way for multi‐focus parallelization approaches while still using compact cw laser sources. Parallelization is further encouraged by the fact that single‐focus scanning velocities are inherently limited by the intermediate‐state lifetime of the photoresist system used. Herein, a 3D nanoprinting setup that combines an established two‐step‐absorption photoresist system with a dynamic multi‐focus approach based on binary holography and a digital micromirror device (DMD) is presented. The generated holographic patterns allow for combined beam‐splitting and beam‐steering as well as for the control of each focus’ individual intensity. Therefore, one obtains a versatile printing approach, enabling a dynamic change of the number of foci for each pattern, based on the structure to be printed. With this setup, the printing of 3D microstructures using up to 31 laser foci in parallel at a print rate of up to is achieved. Additionally, the capabilities and limits of the chosen approach are compared with rate‐equation calculations.
Using two‐step absorption instead of two‐photon absorption in 3D laser nanoprinting reduces demands on necessary laser systems but still poses a challenge for chemistry. Photoresists consisting of a photoinitiator and a viscous monomer are hardened through photopolymerization with one or two different laser sources. Until now, the influence of the photoinitiator type on printing behavior has remained unclear, limiting the rational design of new materials. In this study, we demonstrate a direct connection between molecular design and printing performance, providing new insights that guide the targeted development of novel photoinitiators. One essential parameter in designing new photoinitiators is the laser power required to initiate photopolymerization, which varies with molecular size, regioisomeric substitution, and substituent type. Screenings in this and a previous study about two‐step absorption show that, thus far, the only applicable molecules for this specific 3D printing technique are 1,2‐diketones, primarily benzil derivatives. These compounds are mainly synthesized using a Sonogashira cross‐coupling reaction followed by an oxidation of the resulting triple bond. The photoinitiators introduced in this work can be referred to as two‐step, one‐color systems, allowing 3D structures to be printed using only a single 405 nm laser source.