5 December 2025 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
22 April 2026 in IEEE Transactions on Applied Superconductivity
Superconducting radiation detectors typically exhibit detection and single-photon sensitivity limited to the mid-infrared wavelength range. Extending their detection capabilities into the far-infrared range (>10 μm) requires careful selection of substrate materials and detector geometries. The overall detection efficiency of such detectors is inherently linked to their absorption and coupling efficiencies. In this study, the resonator geometry and its absorption efficiency were estimated using electromagnetic simulations in CST Microwave Studio simulation software for a lumped-element meander structure. Simulations were performed over the 12–50 μm wavelength range, which corresponds to the Infrared Free-Electron Laser (IR-FEL) at RRCAT, Indore. The absorption in the meander inductor was significantly influenced by the substrate material and thickness, as well as the impedance matching between the detector structure and the incident photon medium. The results indicate that SiO2 and diamond substrates are well-suited for developing lumped element kinetic inductance detectors (LEKID) in the above wavelength range. Optimised meander geometries on diamond substrates demonstrated absorption efficiencies of up to 95% for narrow bandwidths and greater than 50% for wide bandwidths. Based on the simulations, a 30-pixel LEKID structure was fabricated by electron-beam lithography on a 500 μm SiO2-coated Si substrate. The resonator was made from a 20 nm-thick Ti40V60 alloy thin film. Optical characterization was also performed through simultaneous transmission and reflection measurements of the 30-pixel LEKID. Simulation studies demonstrate that the designed LEKID structure is well-suited for detecting far-infrared wavelengths above 10 μm, offering high absorption efficiency.
23 September 2026 in Journal of Applied Physics
Fast, highly sensitive, and broadband detectors operating in the mid-to-far-infrared (MIR–FIR) spectral region are essential for applications ranging from astrophysics to time-resolved spectroscopy using laboratory-based sources and beamlines at Infrared Free-Electron Laser (IR-FEL) facilities. Conventional Lumped Element Kinetic Inductance Detectors (LEKIDs) achieve high optical efficiency using resonant quarter-wavelength (λ/4) backshort cavities. However, this cavity-based approach is inherently narrowband and becomes optomechanically challenging at the mid-to-far-infrared (MIR–FIR) wavelengths. Here, we present a completely backshort free LEKID absorber architecture that achieves broadband absorption exceeding 50%. The meander absorbers were fabricated out of superconducting Ti–V alloys and characterized using the IR radiation from the IR-FEL at the Raja Ramanna Centre for Advanced Technology (RRCAT), India. By illuminating through the silicon substrate and matching the sheet resistance of the meander to the wave impedance of the silicon substrate, front-side reflection is strongly suppressed. Simultaneously, the sub-wavelength periodicity of the dense meander inhibits propagating transmission into free space via evanescent-wave confinement. This combined mechanism drives efficient Ohmic dissipation within the metallic meander, yielding an experimental absorption efficiency ranging from 50% to 90% across the 12.5–30 μm wavelength range. The cavity-free design greatly simplifies the focal plane array fabrication while providing the broadband response required for the next-generation detectors. To assess the suitability of the Ti40V60 alloy as an active superconducting detector material, a test LEKID resonator was also designed, fabricated, and experimentally characterized. An RF resonance at a frequency close to the simulated response was observed at temperatures below superconducting transition, thereby confirming the suitability of Ti–V alloys for LEKID development.