18 December 2021 in ACS Applied Nano Materials
X-ray scintillation detectors based on metal halide perovskites have shown excellent light yield, but they mostly target applications with spatial resolution at the tens of micrometers level. Here, we use a one-step solution method to grow arrays of 15-μm-long single-crystalline CsPbBr3 nanowires (NWs) in an AAO (anodized aluminum oxide) membrane template, with nanowire diameters ranging from 30 to 360 nm. The CsPbBr3 nanowires in AAO (CsPbBr3 NW/AAO) show increasing X-ray scintillation efficiency with decreasing nanowire diameter, with a maximum photon yield of ∼5 300 ph/MeV at 30 nm diameter. The CsPbBr3 NW/AAO composites also display high radiation resistance, with a scintillation-intensity decrease of only ∼20–30% after 24 h of X-ray exposure (integrated dose 162 Gyair) and almost no change after ambient storage for 2 months. X-ray images can distinguish line pairs with a spacing of 2 μm for all nanowire diameters, while slanted edge measurements show a spatial resolution of ∼160 lp/mm at modulation transfer function (MTF) = 0.1. The combination of high spatial resolution, radiation stability, and easy fabrication makes these CsPbBr3 NW/AAO scintillators a promising candidate for high-resolution X-ray imaging applications.
3 December 2019 in Journal of Nanomaterials
This study investigated the effect of biogenic AgNPs on seed germination and seedling growth ofSolanum lycopersicum. Treatment with silver nanoparticles (AgNPs) showed a significantly high germination rate and seedling growth compared to untreated seeds. Furthermore, its bactericidal effect against bacterial pathogenClavibacter michiganensissubsp.michiganensis(cmm) infection inSolanum lycopersicumwas also determined. Bacterial canker of tomato (BCT) caused bycmmresults in reduced plant growth and production leading to considerable economic losses. Herein, fungal extracts ofT. harzianumandA. fumigatuswere used separately as a reducing agent to synthesize AgNPs of varying concentrations (0.088 mg/L, 0.176 mg/L, and 0.44 mg/L). Results suggested that the biosynthesized AgNPs not only worked as bactericide but also completely inhibited the incidence ofcmminfection even at the lowest concentration of 0.088 mg/L under greenhouse conditions. Plants treated with AgNPs showed significantly enhanced growth parameters including plant height (cm), tomato yield/plant (g), fresh biomass (g), number of shoots/plant, root weight (g), and dry biomass (g). So, in order to reduce the toxic effects of chemical-based bactericides, biobased AgNPs are recommended, not only to control but also to prevent the bacterial infection in agriculture.
24 March 2022 in Nano Letters
Vertically aligned metal halide perovskite (MHP) nanowires are promising for various optoelectronic applications, which can be further enhanced by heterostructures. However, present methods to obtain free-standing vertically aligned MHP nanowire arrays and heterostructures lack the scalability needed for applications. We use a low-temperature solution process to prepare free-standing vertically aligned green-emitting CsPbBr3 nanowires from anodized aluminum oxide templates. The length is controlled from 1 to 20 μm by the precursor amount. The nanowires are single-crystalline and exhibit excellent photoluminescence, clear light guiding and high photoconductivity with a responsivity of 1.9 A/W. We demonstrate blue-green heterostructured nanowire arrays by converting the free-standing part of the nanowires to CsPbCl1.1Br1.9 in an anion exchange process. Our results demonstrate a scalable, self-aligned, and lithography-free approach to achieve high quality free-standing MHP nanowires arrays and heterostructures, offering new possibilities for optoelectronic applications.
19 February 2020 in Semiconductor Science and Technology
A new environmental transmission electron microscope has been installed in Lund in order to investigate the growth of III–V semiconductor nanowires by metal-organic chemical vapour deposition. We report here on the concepts behind the design of the facility and on details of the operation, and we refer to early results to highlight the new information that can be accessed from in situ studies. The installation includes a gas handling system that delivers the precursors to III–V semiconductor growth under controlled conditions. The core microscope is a Hitachi HF-3300S 300 kV transmission electron microscope with additional pumping that can handle up to 6 Pa of gas injected into the specimen area, or up to 400 Pa if an apertured lid is fitted to the holder. Various custom specimen holders incorporate precursor gas lines, a heating chip or a double tilt mechanism. The polepiece gap has been expanded to accommodate the holders, while the combination of an imaging aberration corrector and a cold field emission gun delivers a point resolution of 86 pm. Single images with atomic level detail are collected by one camera while another camera provides real-time video recording. A scanning unit offers high angle annular dark field and secondary electron images, and compositional microanalysis is performed with energy dispersive spectroscopy. In summary, III–V nanowires have been grown successfully in situ across a range of controlled conditions such as substrate temperature and precursor partial pressures. Atomic resolution images and movies, and spectroscopy data taken during this growth allow detailed measurements of structures, compositions and growth rates—data that are otherwise hard or impossible to obtain from ex situ studies—and further our understanding of the mechanisms of crystal growth.
26 August 2025 in ACS Applied Materials & Interfaces
As artificial intelligence continues to evolve, neuromorphic technologies, which emulate biological neural networks, are increasingly seen as a promising direction. Two-dimensional materials are considered promising for neuromorphic applications due to their tunable electrical and optoelectronic properties. In this work, a back-gated tin disulfide (SnS2) field-effect transistor (FET) is electrically and optoelectronically characterized at different temperatures (80, 295, and 380 K), pressures (ambient and 10-4 mbar), and illumination conditions (dark and laser light from 420 to 800 nm). Responsivity peaks of up to ∼100 A/W are recorded. Persistent photoconductivity is observed, with current retention after illumination ranging from 0% to ∼30% of the initial dark current, depending on temperature and gate voltage. The underlying microscopic mechanisms are analyzed, revealing a key role for trap states and ambient adsorbates, and a qualitative model is proposed to explain the observed effects. Trap states within the bandgap, often considered detrimental, are exploited to induce synaptic plasticity, with synaptic weight changes tunable from 0.001 to 3000. Temperature and gate voltage are found to be effective parameters for modulating plasticity, enabling smooth transitions between short-term and long-term behavior. These results clarify the microscopic origin of plasticity in SnS2, demonstrate its robustness under realistic conditions, and lay the foundation for the integration of this two-dimensional material into next-generation neuromorphic architectures.
3 January 2020 in Advances in Agriculture
Bacterial canker of tomato caused by the bacterial pathogen Clavibacter michiganensis subsp. michiganensis (Cmm) is a major limiting factor for tomato production worldwide. Currently there exists no resistant variety of tomato to bacterial canker; only cultural and chemical controls are available. This study synthesized AgNPs (silver nanoparticles) via a green chemistry route and investigated their bactericidal potential against bacterial canker of tomato (BCT). AgNPs were prepared using mycellial aqueous extract of agriculturally beneficial fungi Pythium oligandrum. The formation of AgNPs was confirmed by using UV–Vis spectroscopy for the absorbance pattern while their morphology was investigated by the transmission electron microscopy (TEM). The X-ray diffraction profile for the biogenic AgNPs confirmed a crystalline structure with an average particle size of 12 nm. AgNPs treated seeds showed a normal germination rate with normal seedling growth. An in-vitro study found that the prepared AgNPs caused the maximum inhibition of the bacterial pathogen. In the greenhouse the introduction of AgNPs significantly prevents and inhibits the bacterial pathogen Cmm on tomato plants. These results suggest that this process is a strong candidate for industrial scale production of AgNPs. These particles act as an inhibitor and broad spectrum antibacterial agent against cmm, and hence offer a new and eco-friendly alternative in BCT control.