Andreas Wank

Andreas Wank

Auto-generated profile, based on publicly available information

Andreas Wank

National Physical Laboratory, Glasgow, U.K.

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 February 2021 in IEEE Transactions on Transportation Electrification
Verified
Journal Article
Open access
Fulin FanFulin Fan
Fulin Fan
AWAndreas Wank
Andreas Wank
Yljon SeferiYljon Seferi
Yljon Seferi
BSBrian Stewart
Brian Stewart
Pantograph arcing in electrified railway systems not only reduces the power collection quality of a locomotive but can also damage pantograph strips and overhead lines (OHLs). Most research detects pantograph-to-OHL arcs based on onboard voltage/current measurements, pantograph cameras, and so on. The use of onboard voltage/current data, though being cost-effective, rarely reflects arc locations along OHLs. This article develops an arc positioning method, which matches the position-dependent resonant frequency (RF) of an OHL with the RF extracted from voltage measurements in a pantograph arc event. A particular 20-km DC railway line supplied by two substations is first modelled in MATLAB/Simulink, with the model effectiveness being assessed based on voltage measurements in an arc event. Then, the OHL-related RFs estimated by the model are validated by the Tableau formula and discussed alongside impacts on RFs based on line models, locomotive locations, and line lengths. These evaluations permit the generation of an RF curve that links OHL-related RFs with arc locations. The arc positioning method is tested based on the pantograph arc events presumed at various positions along the 20-km line, showing errors within 0.2 km at certain locations. The ability to determine arc locations will permit periodic inspections to be performed on the determined line sections.

1 April 2006 in Surface Engineering
Verified
Journal Article
Closed access
BWB. Wielage
B. Wielage
Thomas GrundThomas Grund
Thomas Grund
SAS. Ahrens
S. Ahrens
AWA. Wank
A. Wank
PTProf. Dr.-Ing. Frank Trommer
Prof. Dr.-Ing. Frank Trommer
Application of cold gas spraying to the deposition of braze filler coatings has been investigated. Different light weight alloy substrates, i.e. aluminium AA1050, AA3005, AA5754, AA7022, magnesium AZ91 and titanium Ti–6Al–4V, were used. Filler coating materials depend on the substrate melting temperature. Therefore, for aluminium alloys Al–12Si zinc based fillers are used for AZ91 pure zinc and for Ti–6Al–4V different Cu–Ni blends are used. Cold gas spraying process parameters are varied with regard to process gas (nitrogen) temperature and pressure, powder feedrate and spray distance. Correlation of the process characteristics to economical aspects is given. The viability of the filler coatings produced is illustrated by different optimised brazing/soldering processes. In the case of aluminium braze joints a full metallographical investigation was carried out by optical and scanning electron microscopy as well as EDX analyses. The results obtained are compared with those of conventional filler material additions.