1 December 2020 in Journal of Physics: Conference Series
Electron Beam Welding is an unconventional manufacturing technique widely used in the Aerospace and Defense industries mainly due to the Narrow Fusion Zone (FZ) generated as less metal is melted which leads to less distortion and less amount of heat, as opposed to the other welding processes such as TIG welding and Arc welding. As a result, the solidification of the Weld Joint is in several orders much higher. The Electron Beam Welding process is complex in nature and is controlled by large number of parameters. Parameters such as Accelerating Voltage (Ua), Beam Current (If), Depth of Penetration (H), Beam Focal Diameter (df0) and Welding Speed (v) are part of the Electron Beam Parameters, while Thermo-physical and Chemical properties of the Material and Workpiece Thickness are part of the Parameters influencing Welding Features. This paper also reviews various optimization methods applied by researchers and finally outlines the recommendations and future trends in Electron Beam Welding.
31 October 2015 in Transactions of the Indian Institute of Metals
6 November 2017 in Pigment & Resin Technology
Purpose: The purpose of this paper is to develop a statistical model for delamination and thrust forcing during drilling of carbon-fibre reinforced polymer (CFRP) composites using response surface methodology (RSM) to determine the input parameters (drill speed, drill diameter and feed rate) that influences the output response (delamination and thrust force) in the machining of CFRP composite using solid carbide drill cutter. Design/methodology/approach: Three factors, three levels central composite face centred (CCFC) design, is used to conduct the experiments on CFRP by carbide drill. The whole quality evaluation (delamination) was done by video measuring system to measure the width of maximum damage of the machined CFRP composite. The thrust forces during drilling are measured using digital multi-component cutting force (Make: IEICOS, Model: 652) dynamometer. The “Design Expert 7.0” is used to analyse the data collected graphically. An analysis of variance is carried out to validate the model and for determining the most significant parameter. Findings: The response surface model is used to predict the input factors influencing the delamination and thrust force on the drilled surfaces of CFRP composite at different cutting conditions with the chosen range of 95 per cent confidence intervals. The analysis on the influences of the entire individual input machining parameters on the delamination and thrust force has been carried out using RSM. This investigation revealed that the drill diameter is the eminent factor which affects the responses. Originality/value: In all, 0.3, 0.4 and 0.5 mm holes have been successfully made on CFRP using vertical machining center, whereas the previous researchers have not drilled hole size less than 1 mm in CFRP using vertical machining center.
21 November 2019 in Materials Research Express
BTBhavishya Naik Tejavath
1 March 2020 in Materials Research Express
CVC Thillaiyadi Valliammai
An investigation was conducted on Al-4%Cu alloy sheets to study the role of deformation path on the strength properties, evolution of microstructure and crystallographic texture during cryogenic rolling. Samples were rolled to two distinct thickness strains (50% and 75%) by unidirectional and cross rolling (bidirectional) routes. The strength and hardness properties were found to be more efficient in the cross rolled samples at 50% reduction than their counterparts rolled unidirectionally. Dynamic recovery was observed at higher rolling reductions on cross rolling. Microscopic features observed by EBSD revealed the occurrence of significant grain refinement on the samples rolled with a change of strain path. Also, the alteration of the rolling route resulted in distinct deformation textures and microstructures. TEM studies pointed out the scattered diffusion of the disintegrated dislocation cores and the redistribution of the second phase particles on higher rolling reductions with the change of strain path. Furthermore, the texture results showed a threefold increase on the Goss/Brass ratio which indicated the good fracture toughness behaviour of the cross rolled samples at lower reductions.
25 March 2025 in International Journal of Material Forming