A GaInP/Ga(In)As/GaNAsSb/Ge 4J solar cell grown using the combined MOVPE + MBE method is presented. This structure is used as a test bench to assess the effects caused by the integration of subcells and tunnel junctions into the full 4J structure. A significant degradation of the Ge bottom subcell emitter is observed during the growth of the GaNAsSb subcell, with a drop in the carrier collection efficiency at the high energy photon range that causes a ~15% lower Jsc and a Voc drop of ~50 mV at 1‐sun. The Voc of the GaNAsSb subcell is shown to drop by as much as ~140 mV at 1‐sun. No degradation in performance is observed in the tunnel junctions, and no further degradation is neither observed for the Ge subcell during the growth of the GaInP/Ga(In)As subcells. The hindered efficiency potential in this lattice‐matched 4J architecture due to the degradation of the Ge and GaNAsSb subcells is discussed.
We are developing flexible and lightweight III-V multijuntion solar cells for high power density applications such as unmanned aerial vehicles (drones), High Altitude Pseudo Satellites (HAPS) and high altitude stratospheric balloons for satellite-like communications, cheap and widespread internet connectivity, etc. We focus our research on two different types of III-V solar cells covering the range from 1 kW/kg to 3 kW/kg (considering the weight of the solar cell itself and not that of the module). Our approach to achieve a goal of 3 kW/kg is based on 3J inverted metamorphic solar cells. We have recently developed GaInP/GaAs/GaInAs 3J IMM solar cells with a power density of 5.7 kW/kg under 1xAM1.5g for small areas. Demonstrating large area devices (tens of square cm) is the next challenge to tackle. In addition, we are developing lower-cost designs, targeting 1 kW/kg, based on GaInP/Ga(In)As/Ge 3J lattice matched solar cells. In this paper we present the advances in the modelling and manufacturing of this last type of solar cell. Modelling indicates that there are multiple efficiency-thickness combinations reaching the 1 kW/kg target. For example in the case of AM1.5g, a solar thickness of 46 microns requires an efficiency of 30% which is a demanding value. However, if the thickness is reduced to 40 microns, a more easily achievable efficiency of 27% would be required. We have demonstrated a process for thinning the Ge substrates reaching thicknesses as low as 14 microns with highly homogeneous thickness profiles. Preliminary results show that the 3J thinned solar cell exhibits an efficiency which is the 91% of the efficiency achieved by the non-thinned cell.