1 February 2020 in Composite Structures
19 March 2014 in The Journal of the Textile Institute
Mechanical behavior of woven fabrics under tensile load is complex because their deformation could result from the combined effects of tension, compression, bending, and shear. In this study, the tensile behavior of woven fabrics is simulated using finite element method. The input parameters are the mechanical properties of constituent yarns obtained from tensile and friction coefficient tests and the geometry of woven fabric repeating unit. First, a 3D geometric model of the repeating unit based on Pierce’s model was built using computer-aided design tools. Then, finite element analysis which incorporates material properties, frictional contact, and periodic boundary conditions was implemented using ANSYS. A non-linear mechanical behavior was defined. Frictional contact algorithm for the cross-sectional zone of the repeating unit and periodic boundary conditions to the contour of the repeating unit was implemented. Numerical simulation data and experimental data were compared, which showed good agreement.
1 October 2018 in International Journal of Engineering Science
2 August 2023 in Journal of Building Engineering
29 May 2019 in Textile Research Journal
Auxetic materials are characterized with counter intuitive mechanical behavior, that is, a negative Poisson's ratio, in which the material expands in the direction perpendicular to the elongation direction. This intriguing property can be used to engineer structures with various porosity for ‘smart filters’ where the permeability changes in response to exterior force. In this research, the mechanical behavior of braided tubular structures that comprise helical auxetic yarns (HAYs) has been investigated. The permeability of the structure can be altered with the application of different levels of tensile force. Both HAYs and biaxial structures are fabricated on a Maypole braiding machine. The novelty of this braided tubular structure is that its open area decreases when stretched due to the local auxetic effect. A multi-scale finite element model is established to analyze the auxetic effect and the relationship between tensile force and the open area. The open area of the biaxial structure is measured by a camera system that is installed next to an Instron machine while the sample is subjected to tension. The experimental results show that the open area in the biaxial structure is reduced due to the auxetic effect of each HAY. The model gives a reasonable prediction compared to the experimental data, even though deviation exists, which is probably due to the nonlinear behavior from contact and large deformation.
22 February 2023 in SoftwareX