1 January 2017 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
1 August 2019 in Chemical Engineering Science
7 April 2023 in Fusion Science and Technology
Sufficient cooling of plasma-facing materials remains an outstanding challenge in the design of fusion reactor blankets in commercial power demonstration plants. Due to its chemical inertness and low neutron interaction cross section, pressurized helium is a candidate coolant fluid for such systems; however, helium has a small thermal mass compared to liquid coolants, potentially reducing heat removal performance. To address this need, a number of heat transfer enhancements have been proposed to improve the cooling efficiency of such components, thereby decreasing pumping power needs and improving overall plant efficiency. Toward this end, a helium flow loop experiment (HFLE) has been designed and commissioned to test advanced passive heat transfer enhancements in unit-cell test sections, providing necessary data for model validation and subsequent system design. The HFLE is designed to provide flow of pressurized (up to 4 MPa) helium at flow rates up to 80 g/s, enabling heat transfer and pressure drop measurements in test pieces at Reynolds numbers in excess of 180 000. To explore the effects of novel and complex heat transfer enhancements, test sections are produced via additive manufacturing, providing geometries not typically obtainable by conventional machining. In this work, we present results from HFLE commissioning and the initial thermal-hydraulic tests of an additively manufactured rifled-rib test section. Results are compared to smooth pipe correlations, and plans are described for future HFLE measurements. These preliminary experiments indicate the utility of the HFLE for heat transfer enhancement testing and simulation validation activities.
29 October 2021 in International Journal of Energy Research
1 April 2021 in Fusion Science and Technology
Twisted tape inserts are commonly used for heat transfer enhancement in fusion applications. Although these devices have been extensively studied, existing correlations relating friction factor to Reynolds number and system geometry are applicable only for tight-fitting inserts and cannot account for system roughness and fouling. In this work, we examine pressure losses in twisted tapes of various twist ratios using both a typical twisted tape correlation and a newer formulation that incorporates conventional channel flow correlations. We study flows down to a Reynolds number of 4000 and find that the channel flow treatment predicts experimental outcomes well for turbulent conditions, like those expected in the ITER divertor. For calculations at low Reynolds numbers (expected during start-up and show-down of the divertor), we propose that channel flow correlations be merged with twisted tape correlations. This new, merged correlation is seen to be applicable across all Reynolds numbers observed, although it predicts small divergences among tape pitches at low Reynolds numbers that are not clearly reflected in our experimental data. Experimental and legacy data show that conventional channel flow friction factor correlations can be used under this formulation for pressure drop predictions at Reynolds number above 15 000. We suggest the use of this twisting channel treatment for loose-fitting inserts and systems in which fouling and roughness may be of concern, allowing existing straight channel models to be used for twisted tape pressure drop calculations.