Hennadii Radionov

Hennadii Radionov

Auto-generated profile, based on publicly available information

Hennadii Radionov

National Academy of National Guard of Ukraine Zakhysnykiv Ukrainy sq., 3, Kharkіv, Ukraine, 61001

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 July 2018 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
APAnatolii Panchenko
Anatolii Panchenko
AVAngela Voloshina
Angela Voloshina
SKSergey Kiurchev
Sergey Kiurchev
OTOlena Titova
Olena Titova
DODmytro Onopreychuk
Dmytro Onopreychuk
MGMaksim Golubok
Maksim Golubok
Development of the universal model of mechatronic system with a hydraulic drive

15 January 2018 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PKPavlo Konovalov
Pavlo Konovalov
SVSerhii Voronin
Serhii Voronin
DODmytro Onopreychuk
Dmytro Onopreychuk
VSVolodymyr Stefanov
Volodymyr Stefanov
VPViktor Pashchenko
Viktor Pashchenko
AOAleksandr Onoprienko
Aleksandr Onoprienko
The effect of electrostatic processing on performance characteristics of axle oil is investigated. Axle oil is used for wetting motor-axial bearings (MAB) of locomotives. There is a pressing and urgent problem of the MAB service life, which is indirectly related to the underdeveloped reserves of anti-wear properties of axle oil. To study them, it was decided to use the method of electrostatic processing, which does not require the introduction of any additives and has proven its effectiveness in the studies of other mineral oils. It is based on the ability of electric fields to destroy micellar aggregates in oil and form a solid boundary layer of molecules on friction surfaces. In the context of solving the current problem of the MAB service life, this method wasn’t considered earlier. The research was carried out by means of the «roller-pad» friction pair, which was wetted with axle oil at different load conditions and operating times. The dependences of wear of the experimental samples under different load conditions, oil operating times and degrees of electric processing are obtained. The results show that when using axle oil subjected to ESP, the wear rate of the experimental samples is reduced. Wear rate reduction depends on the oil operating time in the lubrication system. The greatest wear rate reduction of 1.92 times is noted for fresh oil. For the oil state after the locomotive run of 75 thousand km, the reduction is about 1.68 times and for the oil at the end of its service life, wear rate reduction is approximately 1.47 times.

1 January 2023 in The Scientific Journal of the National Academy of National Guard "Honor and Law"
Verified
Journal Article
Open access
PDF file
PPP. Pistryak
P. Pistryak
NUNational Academy Of The National Guard Of Ukraine
National Academy Of The National Guard Of Ukraine
БКБогдан Кушнарьов
Богдан Кушнарьов
HRH. Radionov
H. Radionov
Деталізовано процес виконання вогневого завдання. На основі проведених досліджень виявлено і наведено залежності між контрастністю цілі на умовно однорідному фоні та ймовірністю виконання вогневого завдання. Запропоновано рекомендації з методики вогневої підготовки та поставлено завдання подальших досліджень.

2 April 2019 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
SVSerhii Voronin
Serhii Voronin
OSOleksii Suranov
Oleksii Suranov
DODmytro Onopreichuk
Dmytro Onopreichuk
VSVolodymyr Stefanov
Volodymyr Stefanov
SKSerhii Kryvonogov
Serhii Kryvonogov
MHMykyta Horbachov
Mykyta Horbachov
Determining the influence of carbon black in oil on the wear resistance of elements in the tribological system "steel – oil – bronze"

1 January 2023 in The collection of scientific works of the National Academy of the National Guard of Ukraine
Verified
Journal Article
Open access
PDF file
M"Military Institute of Tank Troops of the National Technical University "
Military Institute of Tank Troops of the National Technical University "
YKYu. Krasnoshapka
Yu. Krasnoshapka
KIKharkiv Polytechnic Institute"
Kharkiv Polytechnic Institute"
KKK. Korycthenko
K. Korycthenko
MIMilitary Institute of Tank Troops of the National Technical University "Kharkiv Polytechnic Institute"
Military Institute of Tank Troops of the National Technical University "Kharkiv Polytechnic Institute"
HRH. Radionov
H. Radionov
The paper presents the results of a comparative study of the PT-800 and PN-800 converters in the 2E42 tank weapon stabilizer in the start-up and emergency modes. The research was carried out on the T-64B tank by remote connection of converters under similar load conditions. The current was measured by 3 ACS756 current sensors, the signals from which were recorded on a Rigol DS1104Z digital oscilloscope with an input frequency of 100 MHz. The line voltage was measured using a Tektronix TDS 3014B oscilloscope. For a comparative study of the influence of PT-800 and PN-800 converters on the output of 3-phase current consumers in the operating mode, a 2E42 gyro tachometer of the vertical guidance drive of the stabilizer of tank weapons was used. The gyro tachometer rotor rotation frequency was measured with a Walcom DT-2234C+ tachometer using a non-contact method. The time dependences of the gyrotachometer output to the nominal mode from different power sources are obtained. It was measured that the time for the gyro tachometer to reach the nominal mode does not exceed the normative start-up time of 120 s, which is indicated in the instructions. The use of frequency regulation of start-up to reduce the time of output of the converter to the nominal mode is substantiated. At a reduced power supply frequency, there is a multiple increase in the electromagnetic moment at the start-up speed, which is a prerequisite for reducing the output time of the converter to the nominal mode. We observed that after a phase-to-phase shorting on the PT-800 converter, the current increases to 60-70 A, i.e. 7-10 times. Such a multiple increase in current can lead to failure of the tank's electrical network in the event of an emergency shutdown of the PT-800 converter. After the phase-to-phase shorting of the output of the PN-800 converter, the linear current instantly decreased to zero for 1-2 s, then it gradually increased over 500 ms, and after reaching the maximum, the current disappeared. According to the results of short-circuit current measurements on the PN-800 converter, we have an increase in current to 15-20 A, that is, by 1.5-2 times. It was found that the PN-800 converter has a significant advantage over the PT-800 converter in terms of operation in emergency mode. У статті подано результати порівняльного дослідження роботи перетворювачів ПТ-800 та ПН-800 у стабілізаторі танкового озброєння 2Е42 у пусковому та аварійному режимах. Дослідження проведене на танку Т-64Б шляхом виносного підключення перетворювачів у подібних умовах навантаження. Отримані залежності часу виходу гіротахометра на номінальний режим від різних джерел живлення. Обґрунтовано застосування частотного регулювання пуску для скорочення часу виходу перетворювача на номінальний режим.

1 January 2022 in The collection of scientific works of the National Academy of the National Guard of Ukraine
Verified
Journal Article
Closed access
PDF file
TUThe National Academy Of The National Guard Of Ukraine
The National Academy Of The National Guard Of Ukraine
HRH. Radionov
H. Radionov
ВМВолодимир Марченко
Володимир Марченко
ГРГеннадій Радіонов
Геннадій Радіонов
ВГВолодимир Гриняк
Володимир Гриняк
The scientific-methodical apparatus for predicting damage to biological objects of non-lethal kinetic weapons is considered, which mainly takes into account only the energy characteristics of the damaging elements, namely, kinetic and specific energy. An analysis of the nominal ballistic characteristics of samples of non-lethal kinetic weapons, which are in service with law enforcement agencies and military formations of Ukraine, was carried out, based on the determination of only the specific energy of the striking elements. The energy characteristics of bullets or striking elements for various samples of non-lethal kinetic weapons vary within fairly wide limits. In particular, such an important indicator as the specific energy varies from 0.34 to 1.33 J/mm2, that is, even the same type of weapon, intended for use at certain distances to the target, in the case of using different cartridges, has a significantly different specific energy (the difference reaches 30%). An analysis of known developments in the field of terminal ballistics is given, which indicates the need to take into account the speed of meeting the target under the conditions of conservation of constant kinetic energy. So, with the same mass, a bullet with a higher speed will have more energy. Such a ball has the ability to give a different part of its energy to the affected tissues. The main feature of cartridges with a traumatic effect, which distinguishes them from ordinary cartridges for firearms, is the mechanical characteristics of the striking elements. The striking elements require a high "stopping" effect, i.e. quick and complete incapacitation of the opponent when hitting any part of the body - this is a short range of "fire contact". For this, striking elements must quickly and maximally transfer their kinetic energy to the target upon hitting it. Therefore, most bullets for police and civilian weapons are blunt-end ("impact") - with a rounded or flat area on the main part. So important are the shape and strength (stiffness) of the striking elements and the shape of the main part that directly interacts with the target. The need to improve the scientific and methodological apparatus for predicting damage to biological objects when using non-lethal kinetic weapons by taking into account an expanded list of factors (speed, strength, rigidity and shape of the striking element) in order to increase the adequacy of the obtained models is substantiated. Розглянуто науково-методичний апарат прогнозування ушкоджень біологічних об’єктів кінетичною зброєю несмертельної дії. Наведено аналіз відомих напрацювань в області термінальної балістики. Обґрунтовано необхідність вдосконалення науково-методичного апарату прогнозування ушкоджень біологічних об’єктів при застосуванні кінетичної зброї несмертельної дії з метою підвищення адекватності отриманих моделей.