1 July 2013 in Chemical Engineering Journal
1 December 2014 in Chemical Engineering Journal
AYAbdull Rahim Mohd Yusoff
15 March 2018 in Combustion Science and Technology
Activated carbon derived from sea mango (cerbera odollam), SMAC, was developed from phosphoric acid (H3PO4) activation. Box-Behnken Design (BBD) was employed to optimize the surface area of the SMAC. The tested factors were acid concentration (40 to 60%), carbonization temperature (400 to 600°C) and activation time (1 to 3 h). The optimized parameters were 53.75% H3PO4 concentration, 519.8°C of carbonization temperature and 2.3 h of activation time, which resulted in 857.93 m2/g of BET surface area. The performance of CO2 adsorption was investigated for modified and virgin SMAC. The impregnations of SMACs were done with different amines (AMP, PZ and MEA) to improve its natural adsorption ability and promote nitrogen functional group onto carbon surface with impregnation mass ratio of 2:5 (amine: activated carbon). The effects of adsorption parameters such as activated carbon properties, type of amine used, gas flow rate and adsorbent dosage on breakthrough curves and adsorption bed capacity were evaluated. Reduction in BET surface area indicates that the amine-based chemicals were successfully attached on carbon surface and thus blocked most of the pores on the SMAC particles. The modified surface of SMAC with AMP amine showed the best performance in CO2 adsorption and regeneration with adsorption bed capacity of 23.05 mgCO2/g sorbent. Successful CO2 adsorption via modified surface of SMAC suggested that it is viable to use sea mango as alternative precursor for activated carbon preparation and in application such as CO2 capture.
1 October 2013 in Journal of Hydrology
11 April 2018 in IOP Conference Series: Earth and Environmental Science
Lake water in UTHM was slightly greenish in color indicating the eutrophication process. Eutrophication problem is due to excessive amount of nutrient in the lake water which causes nuisance growth of algae and other aquatic plant. The improvement of lake water quality should be conducted wisely in preventing from eutrophication problem by using a suitable water treatment method. Natural materials, agricultural wastes and industrial wastes are locally available sources can be utilized as low-cost adsorbents. The natural abundant source of waste mussel's shells is advantages to use as basis material to produce the low cost adsorbent for water treatment. Batch experiments were carried out with the preparation 500 ml volume of lake water sample with the dosage of 2.5g, 7.5g and 12.5g. Then the solution shaking in an incubator with 200 rpm shaking speed. The various dosage of mussel shell greatly affected pollutants removal. Both of NH4+ and PO43- have a higher percentage removal with 31.28% and 21.74% at the 7.5g of sample dosage. Other parameters such as COD and TSS also shown good percentage of removal at 7.5g of dosage sample with 44.45% and 25% respectively. While, dosage at 2.5g was performed as a good adsorption capacity of NH4+, PO43-, COD and TSS as high as 0.142, 0.234, 7.6 and 20 mg/g, respectively. These experimental results suggested that the use of mussel shell powder as good basis material in removing pollutants from lake water.
17 January 2023 in Environmental Research
NHNurul.ATikah Heshammuddin
Nurul.ATikah Heshammuddin