Improved frequency compensation is proposed for a three-stage amplifier with reduced total capacitance, improved slew rate, and reduced settling time. The proposed compensation uses an auxiliary feedback to increase the total effective compensation capacitance without loading the output node. The proposed compensation scheme is validated in simulation by implementing a three-stage amplifier driving 10 pF load capacitor in a 0.18 μm CMOS process. A detailed comparison of the compensation with a conventional nested Miller compensation is also presented. The simulation results showed a reduction in total compensation capacitance and improvement in slew rate compared to conventional nested Miller compensation and the other reported techniques in the literature.
A fully-integrated switched-capacitor (SC) DC-DC converter that steps down 2.0 V to 0.9 V with a peak efficiency of 80% is implemented in a 0.18 m CMOS process. An ultra-low-power voltage-controlled oscillator that generates a wide range of switching frequencies is proposed to extend battery runtime. An efficiency >70% for load currents in the range of 12 A to 17.8 mA is achieved by implementing a novel adaptively-biased pulse frequency modulation (ABPFM) technique in the controller. A symmetric charge-discharge topology with two-phase time interleaving is used as a power stage to reduce the output voltage ripple to <72 mV over the entire load current range.
A frequency spectrum segmentation methodology is proposed to extract the frequency response of circuits and systems with high resolution and low distortion over a wide frequency range. A high resolution is achieved by implementing a modified Dirichlet function (MDF) configured for multi-tone excitation signals. Low distortion is attained by limiting or avoiding spectral leakage and interference into the frequency spectrum of interest. The use of a window function allowed for further reduction in distortion by suppressing system-induced oscillations that can cause severe interference while acquiring signals. This proposed segmentation methodology with the MDF generates an interleaved frequency spectrum segment that can be used to measure the frequency response of the system and can be represented in a Bode and Nyquist plot. The ability to simulate and measure the frequency response of the circuit and system without expensive network analyzers provides good stability coverage for reliable fault detection and failure avoidance. The proposed methodology is validated with both simulation and hardware.