A detailed method used for assessing and mapping noise pollution levels in Ota metropolis, Nigeria using ArcGIS 10.5 Software is presented in this paper. Noise readings were measured at a time interval of 30 min for each site considered using a precision grade sound level meter. The noise map developed was based on the computed values of average equivalent noise (LAeq) for the selected locations. Results of this study show that the A weighted sound level (LAeq), the background noise level (L10) and the peak noise level (L90) vary with location and period of the day due to traffic characteristics especially traffic volume, vehicle horns, vehicle mounted speakers, and unmuffled vehicles at road Junctions, major roads, motor parks and commercial centres. Based on the U.S. Department of Housing and Urban Development (HUD) recommendations and standards, only one (1) out of the 41 locations considered is under normally acceptable situation, while 12 locations are under normally unacceptable and the noise levels of the rest locations are clearly unacceptable. Results of this study are useful as reference and guideline for future planning and regulations on noise limit to be implemented for urban areas like Ota Metropolis. •Instrumentation used in this study for the environmental noise measurements consisted of a precision-grade sound-level meter - Model 8922 RS232.•The Geographical Positioning System (GPS) device (model: Magellan eXplorist 310) was used to obtain the exact coordinates of each location where noise level readings were recorded.•ArcGIS 10.5 software was used in this study to develop noise map for Ota Metropolis.
10 June 2020 in Journal of Thermal Analysis and Calorimetry
Sub-Sahara Africa is renowned for poor electricity supply with Nigeria’s case being critical. Generator sets, which have been adopted as an alternative and reliable source of power in Nigeria, are linked to emission footprints detrimental to the environment and human health. The dearth of literature in open domain on the concentrations of pollutants and potential health risk related to the use of gasoline-fueled generators prompted this study. Concentrations of CO2, CO and particulate matter (PM2.5) emitted from selected randomly 174 gasoline-powered household generators were measured. Standard instruments were employed to measure these concentrations at 0.3–0.5 m from the exhaust pipe for 1 h (at 10 mins interval). The study area was Sango, Ogun State, Nigeria. The obtained results were 710 ± 19.1 ppm, 83 ± 4.0 ppm and 83 ± 4.1 µg/m3 (average) for CO2, CO, and PM2.5, respectively. The regression analyse carried out on the data for the age and efficiency of the generators in relation to the concentration data of CO2, CO and PM2.5 showed that the efficiency (R = 0.92 and F = 301.3) has more impact on the concentrations than the age (R = 0.68 and F = 49.6). Also, the efficiency of the generators was observed to have positive and significant effect on both the CO2 (t-stat = 10.05 and P-value = ≪ 0.050) and PM2.5 (t-stat = 2.26 and P-value = 0.025) concentrations. The average concentrations of CO2 and PM2.5 were observed to be higher than those recommended by the World Health Organization. Health impact assessment revealed hazardous and unhealthy status for CO and PM2.5 with air quality indices of >500 and 178.8, respectively. This study recommends efficient use of generators, fuel switching (gasoline to LPG), stringent emission measures and use of renewable energy as possible solutions.