Three different types of feedstocks and their biochars were used to remove Cr(III), Cd(II), Cu(II) and Pb(II) ions from a mixture of multiple heavy metals. The effect of the initial concentration of heavy metals in solution has been analysed, and kinetics modelling and a comparison of the adsorption capacity of such materials have been performed to elucidate the possible adsorption mechanisms. The results show that the adsorption capacity is dependent on the type of feedstock and on the pyrolysis conditions. The adsorption capacity of the biomass types is ranked as follows: FO (from sewage sludge)>> LO > ZO (both from agriculture biomass waste)>> CO (from wood biomass waste). Biochars, which are the product of the pyrolysis of feedstocks, clearly improve the adsorption efficiency in the case of those derived from wood and agricultural biomasses. Complexation and cation exchange have been found to be the two main adsorption mechanisms in systems containing multiple heavy metals, with cation exchange being the most significant. The pore structure of biomass/biochar cannot be neglected when investigating the adsorption mechanism of each material. All the disposal biomasses presented here are good alternatives for heavy metal removal from wastewaters.
1 February 2021 in Science of The Total Environment
Water pollution is an environmental problem that affects the ecosystem and living beings. Adsorption is one of the best technologies for the removal of heavy metals. Since waste recovery is the basis of the Circular Economy, agro-industrial waste is emerging as low-cost adsorbents for these pollutants from wastewater. Residues of pine sawdust, sunflower seed hulls and corn residues mix were evaluated as adsorbents of synthetic aqueous solutions of Ni(II), Zn(II) and Cd(II). These residues were characterized to determine their structure and composition, and to understand the adsorption mechanism. Adsorption efficiencies and capacities for the adsorbents and adsorbates were determined and compared. From the obtained results, it is possible to affirm that all biomasses used are good alternatives to the synthetic materials, with adsorption efficiencies greater than 50%. The order of adsorption was Cd > Zn > Ni. At the concentration range checked, adsorption efficiencies decreased in sawdust when a mixture of all metals together was considered (as present in real sewage). Finally, the heavy metals were immobilized, with efficiencies over 88.5%, in clay ceramics (as brick’s precursors). This procedure would help to minimize the contamination that could be generated by the disposal of spent adsorbents, rarely explored in the literature.