Hydrogen has been attracting attention as a fuel in the transportation sector to achieve carbon neutrality. Hydrogen storage in liquid form is preferred in locomotives, ships, drones, and aircraft, because these require high power but have limited space. However, liquid hydrogen must be in a cryogenic state, wherein thermal insulation is a core problem. Inner materials, including glass bubbles, multi-layer insulation (MLI), high vacuum, and vapor-cooled shields, are used for thermal insulation. An analytic study is preferred and proceeds liquid hydrogen tanks due to safety regulations in each country. This study reviewed the relevant literature for thermodynamic modeling. The literature was divided into static, dynamic, and systematic studies. In summary, the authors summarized the following future research needs: The optimal design of the structure, including suspension, baffle, and insulation system, can be studied to minimize the boil-off gas (BOG). A dynamic study of the pressure, mass flow, and vaporizer can be completed. The change of the components arrangement from the conventional diesel–electric locomotive is necessary.

This paper reviews the major researchers of liquid, immersion, and two-phase cooling. Currently, liquids are used instead of air to cool the growing data centers. Immersion cooling shows a higher heat transfer coefficient than conventional cooling (<37 W/cm²). Because the use of liquids with high global warming potentials is prohibited, the number of liquids that can be used is limited. This paper discusses the existing, relevant literature from researchers who have studied the issue at least thrice. The authors were divided into those who focused on the surface and those who formed a structure on the surface. In summary, the authors suggested the following research directions: The experimental conditions of porous foam are not diverse, and there is a concern about the separation of foam and coating into the tub. The experimental conditions of the immersion tub should also be varied according to the heat and pressure over time. Structure-level research shows higher performance than surface-level research, but an economic feasibility study is required.

Liquid hydrogen has been studied for use in vehicles. However, during the charging process, liquid hydrogen is lost as gas. Therefore, it is necessary to estimate and reduce this loss and simulate the charging process. In this study, the initial charging process of a vehicle liquid hydrogen tank under room temperature and atmospheric pressure conditions was numerically investigated. A transient thermal-fluid simulation with a phase-change model was performed to analyze variations in the volume, pressure, mass flow rate, and temperature. The results showed that the process could be divided into three stages. In the first stage, liquid hydrogen was actively vaporized at the inner wall surface of the storage tank. The pressure increased rapidly, and liquid droplets were discharged into the vent pipe during the second stage. In the third stage, the mass flow rates of liquid and hydrogen gas at the outlet showed significant fluctuations, owing to complex momentum generated by the evaporation and charging flow. The temperatures of the inner and outer walls, and insulation layer, decreased significantly slower than that of the gas region because of its high heat capacity and insulation effect. The optimal structure should be further studied because the vortex, stagnation, and non-uniform cooling of the wall occurred near the inlet and outlet pipes.