Doğaç TARI

Mr. Doğaç TARI

Nuclear Chemistry, Chalmers University of Technology, Gothenburg, Västra Götaland, Sweden
orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 October 2021 in Reaction Kinetics, Mechanisms and Catalysis
Verified
Journal Article
Closed access
PDF file
SASemih Ates
Semih Ates
DTDoğaç TARI
Doğaç TARI
ŞSŞerzat Safaltın
Şerzat Safaltın
BKBurak Küçükelyas
Burak Küçükelyas
Duygu Yeşiltepe ÖzçelikDuygu Yeşiltepe Özçelik
Duygu Yeşiltepe Özçelik
SGSebahattin Gürmen
Sebahattin Gürmen

6 February 2024 in Journal of Nuclear Engineering
Verified
Journal Article
Open access
PDF file
DTDoğaç TARI
Doğaç TARI
Teodora Retegan VollmerTeodora Retegan Vollmer
Teodora Retegan Vollmer
CGChristine Geers
Christine Geers
High temperature corrosion of fuel cladding material (15-15Ti) in high burn-up situations has been an important topic for molten metal-cooled Gen-IV reactors. The present study aims to investigate the simultaneous impact of liquid lead (coolant side) and cesium molybdate (fuel side) on the cladding tube material. A capsule was designed and built for experiments between 600 °C and 1000 °C. In order to simulate a cladding breach scenario, a notch design on the cladding tube was investigated pre- and postexposure. Material thinning by corrosion and leaching at temperatures ≥ 900 °C caused breaches at the notches after 168 h exposure. The temperature dependent cladding thinning phenomenon was used for kinetic interpretation. As the first of a two-part study, this paper will focus on the exposure capsule performance, including metallographic cross-section preparation and preliminary results on the interface chemistry.

22 December 2023 in ECS Meeting Abstracts
Verified
Journal Article
Closed access
DTDoğaç TARI
Doğaç TARI
Teodora Retegan VollmerTeodora Retegan Vollmer
Teodora Retegan Vollmer
CGChristine Geers
Christine Geers
Lead-Cooled Fast Reactors are one of the emerging new technologies connected to the Generation IV reactor designs. Even though the reactor features are extensive and beneficial, some technical and regulatory difficulties remain that hinder the deployment. One of them is the corrosion behavior of fuel claddings in high burn-up and elevated temperatures, as fuel claddings are a part of accident barriers. In this study, 15-15Ti austenitic steel was the investigated cladding material. As this cladding would be used in a tube form, corrosion attack from both sides, inside and outside is studied in contact to their respective environments. From the outside of the tube, the proposed coolant liquid lead is the corrosive substance. At the inside of the tube, the major corrosive species in our test setup is, for simplicity reasons, Cs2MoO4. However, this choice has been made from some considerations regarding the fuel evolution upon burn-up. In a high burn-up situation, the generated fission products would start to accumulate to the gap between the fuel pellet and the cladding tube. These accumulated products are the so-called “Joint-Oxide Gain” (JOG) phases, and they are the corrosive substances in question when discussing the corrosion attack from the inside of a cladding tube. Cs2MoO4 has been identified as one of the main components of JOG phases and thus will be focused on in this study. A new capsule was designed to investigate the dual-atmosphere corrosion of cladding tubes. Unexposed capsule parts (a) and the basic schematic of the assembled capsule (b) can be seen in the Figure below. The cladding tube material itself is used as the container for JOG as it is filled with Cs2MoO4 and sealed on both ends. This assembly is then placed inside a bigger capsule, which is filled with lead powder to submerge the cladding tube assembly. All assemblies were done in Ar-filled glovebox. The capsules were then exposed to 600-1000 oC for 52 to 168 hours, which was followed by cutting and epoxy embedding to investigate the cross-sections. Figure 1

4 November 2026 in Journal of Nuclear Science and Technology
Verified
Journal Article
Open access
DTDoğaç TARI
Doğaç TARI
CGChristine Geers
Christine Geers
Teodora Retegan VollmerTeodora Retegan Vollmer
Teodora Retegan Vollmer