The paper reports experimental research regarding the mechanical characteristics of concrete reinforced with natural cellulosic fibers like jute, sisal, sugarcane, and coconut. Each type of natural fiber, with an average of 30 mm length, was mixed with a concrete matrix in varying proportions of 0.5% to 3% mass. The tensile and compressive strength of the developed concrete samples with cellulosic fiber reinforcement gradually increased with the increasing proportion of natural cellulosic fibers up to 2%. A further increase in fiber loading fraction results in deterioration of the mechanical properties. By using jute and sisal fiber reinforcement, about 11.6% to 20.2% improvement in tensile and compressive strength, respectively, was observed compared to plain concrete, just by adding 2% of fibers in the concrete mix. Bending strength increased for the natural fiber-based concrete with up to 1.5% fiber loading. However, a decrease in bending strength was observed beyond 1.5% loading due to cracks at fiber−concrete interface. The impact performance showed gradual improvement with natural fiber loading of up to 2%. The water absorption capacity of natural cellulosic fiber reinforced concrete decreased substantially; however, it increased with the loading percent of fibers. The natural fiber reinforced concrete can be commercially used for interior or exterior pavements and flooring slabs as a sustainable construction material for the future.
1 September 2020 in Journal of Building Engineering
Finishes bring an alteration to the physical and comfort properties of the textiles. That’s why various finishes are used to impart various functionalities to the fabric surface. However, it may also affect some properties. The purpose of this study is to investigate the effect of various finishes on pilling, mass per unit area, bursting strength, and wicking behavior of the polyester weft-knitted jersey fabric. Herein, 100% spun polyester weft-knitted plain jersey fabric was exposed to different finish treatments to check their effect on the some physical and comfort properties of the fabric like mass per unit area, pilling behavior, bursting strength, and wicking properties of the weft-knitted jersey fabric. The fabric used was knit from 24/1, 100% spun polyester yarn on the single knit circular knitting machine. The developed fabric was washed on Fong machine. Finishes are applied on fabric by “Monofort Stanter” machine. The resultant fabric was characterized by random tumble pilling tester, bursting strength tester, and wicking tester to analyze their pilling grade, bursting strength, and wicking behavior respectively. A significant increase has been found in wicking behavior, mass per unit area, and bursting strength of the fabric after finishing treatments. Moreover, the wicking finish shows the highest reduction in pilling grade from 3.5 to 2.5. Significant improvement has been observed in bursting strength by all finish’s treatment. However, wicking finish treatment results in the highest increase in bursting strength of 4.2%. Significant improvement has been observed in the vertical wicking speed of all treatment except silicon finish which significantly reduces vertical wicking rate. However, the wicking finish (Recipe E) shows the highest increase in wicking rate by 13.75 times as compared to grey fabric.