Даниил Valerievich Нечаев

Mr. Даниил Valerievich Нечаев

Scientific technological complex "new technologies and materials", Peter the Great St. Petersburg Polytechnic University, Saint Petersburg, Sankt-Peterburg, Russia
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 December 2022 in Metals
Verified
Journal Article
Open access
PDF file
AZAndrey Zhitenev
Andrey Zhitenev
ARAnna Rovbo
Anna Rovbo
ДНДаниил Valerievich Нечаев
Даниил Valerievich Нечаев
NSNikita Shaposhnikov
Nikita Shaposhnikov
SRSergey Ryaboshuk
Sergey Ryaboshuk
AAAlexey Alkhimenko
Alexey Alkhimenko
The paper investigates the behavior of bismuth and sulfur in modern free-cutting steels. It is shown that today there are no mutually consistent thermodynamic data for calculating the solubility of bismuth in a multi-component steel system. Based on the processing of data from separate works, mutually consistent dependences of the solubility of bismuth in pure iron, as well as Wagner interaction parameters for calculation for steels, were obtained. An attempt was made to model the formation of bismuth simultaneously with manganese sulfides during solidification based on the Ohnaka segregation model. Comparison with experimental data shows acceptable convergence of calculations and experiments.

30 October 2026 in Oil and Gas Studies
Verified
Journal Article
Open access
PDF file
AKA. I. Kolotiy
A. I. Kolotiy
SES. B. Ermakov
S. B. Ermakov
BEB. S. Ermakov
B. S. Ermakov
ДНДаниил Valerievich Нечаев
Даниил Valerievich Нечаев
АКА. И. Колотий
А. И. Колотий
ДНД. В. Нечаев
Д. В. Нечаев
The expanding use of polymer composites in infrastructure calls for recycling routes after the end of service. This study evaluates mechanically ground material from a hybrid basalt/glass-fibre composite pile as a filler for acrylonitrile butadiene styrene (ABS) filament and three-dimensional printing. Formulations containing 0, 10, 20 and 30 wt.% recyclate of a 0.10–0.20 mm sieve fraction were used to print two tensile and three three-point-bending specimens per formulation. The printing nozzle temperature was 260 °C. Mean maximum tensile stress decreased from 44.21 MPa for unfilled ABS to 35.49, 32.35 and 20.00 MPa, while flexural stress decreased from 79.58 to 70.46, 58.88 and 43.80 MPa, respectively. Flexural modulus remained within 2.60–2.77 GPa. At 30 wt.%, filament brittleness, winding difficulties and intermittent extrusion-nozzle clogging limited continuous filament length to 10 m. Formulations containing 10–20 wt.% recyclate warrant further development for auxiliary products whose intended use permits reduced mechanical performance. The results support further optimization of particle classification and processing conditions but do not establish a universally optimal formulation.