Emmanuvel Joseph Aju

Mr. Emmanuvel Joseph Aju

UTD
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 December 2022 in Wind Energy
Verified
Journal Article
Open access
Devesh KumarDevesh Kumar
Devesh Kumar
Mario RoteaMario Rotea
Mario Rotea
Emmanuvel Joseph AjuEmmanuvel Joseph Aju
Emmanuvel Joseph Aju
YJYaqing Jin
Yaqing Jin
This work describes the results from wind tunnel experiments performed to maximize wind plant total power output using wake steering via closed loop yaw angle control. The experimental wind plant consists of nine turbines arranged in two different layouts; both are two dimensional arrays and differ in the positioning of the individual turbines. Two algorithms are implemented to maximize wind plant power: Log‐of‐Power Extremum Seeking Control (LP‐ESC) and Log‐of‐Power Proportional Integral Extremum Seeking Control (LP‐PIESC). These algorithms command the yaw angles of the turbines in the upstream row. The results demonstrate that the algorithms can find the optimal yaw angles that maximize total power output. The LP‐PIESC reached the optimal yaw angles much faster than the LP‐ESC. The sensitivity of the LP‐PIESC to variations in free stream wind speed and initial yaw angles is studied to demonstrate robustness to variations in wind speed and unknown yaw misalignment.

6 October 2020 in Energies
Verified
Journal Article
Open access
PDF file
Emmanuvel Joseph AjuEmmanuvel Joseph Aju
Emmanuvel Joseph Aju
DSDhanush Bhamitipadi Suresh
Dhanush Bhamitipadi Suresh
Yaqing JinYaqing Jin
Yaqing Jin
The objective of this study is to investigate the influence of winglet pitching as an aero-brake on the performance of a model wind turbine by wind tunnel experiments. Time-resolved particle image velocimetry, force sensor, and datalogger were used to characterize the coupling between wake statistics, aerodynamic loads, and rotation speed. Results highlighted that, for a winglet with 4% of the rotor diameter length, the increase of its pitching angle can significantly reduce the turbine rotation speed up to ∼28% and thrust coefficient of ∼20%. The winglet pitching induced minor influence on the velocity deficit in the very near wake regions, while its influence on accelerating the wake recovery become clear around three diameters downstream the turbine rotor. The turbulence kinetic energy exhibited a distinctive increase under large pitching angles in the near wake region at the turbine hub height due to the strong vertical flow fluctuations. Further investigation on the spectra of wake velocities revealed that the pitching of winglet can suppress the high-pass filtering effects of turbines on wake fluctuations; such large-scale turbulence facilitated the flow mixing and accelerated the wake transport.

1 August 2021 in Physics of Fluids
Verified
Journal Article
Closed access
PDF file
DSDhanush Bhamitipadi Suresh
Dhanush Bhamitipadi Suresh
Emmanuvel Joseph AjuEmmanuvel Joseph Aju
Emmanuvel Joseph Aju
DPDat Thanh Pham
Dat Thanh Pham
Yaqing JinYaqing Jin
Yaqing Jin
The incipient sediment suspension downstream of a thin square tab with various inclination angles was fundamentally described using experiments and theoretical arguments. Volumetric particle tracking velocimetry and particle image velocimetry were applied to measure the sediment particle distributions and wake flows under various incoming velocities and obstacle inclination angles. Results show that suspension of sediments occurred downstream of the obstacles due to the enhanced local turbulence intensities. Although the sediment volumetric fraction was mostly determined by the variation of wake turbulence kinetic energy under low inclination angles (i.e., obstacles nearly parallel to incoming flow), this was not the case under high inclination angle counterparts where distinct downward velocities dominated the wake region and suppressed the sediment suspension. This led to the decrease of sediment volumetric fraction with the growth of tab inclination at high inclination angles. Supported by flow measurements, a revised Rouse number was introduced which allows to quantitatively integrate the coupled influence of turbulence mixing load and vertical flows across various incoming velocities and inclination angles.

20 January 2022 in Experiments in Fluids
Verified
Journal Article
Closed access
PDF file
Emmanuvel Joseph AjuEmmanuvel Joseph Aju
Emmanuvel Joseph Aju
PGPengyao Gong
Pengyao Gong
DPDat Thanh Pham
Dat Thanh Pham
KKKartikeya Kaushik
Kartikeya Kaushik
Yaqing JinYaqing Jin
Yaqing Jin

1 June 2022 in Physics of Fluids
Verified
Journal Article
Closed access
PGPengyao Gong
Pengyao Gong
Emmanuvel Joseph AjuEmmanuvel Joseph Aju
Emmanuvel Joseph Aju
Yaqing JinYaqing Jin
Yaqing Jin
The aerodynamic performances and flow statistics for a Delft University-91-W2-250 airfoil with deformable vortex generators (DVG) were experimentally studied in a wind tunnel across various angle of attacks and wind speeds. A high-resolution force sensor was used to measure the time-averaged lift force, while a planar particle image velocimetry system was applied to characterize the mean velocity and vortex shedding over airfoil surface. The results highlighted that, similar to conventional rigid vortex generators (RVG), DVG can effectively enhance lift coefficient after the stall angle of airfoil with clean surface under low incoming winds. However, the deformation of DVGs increased with the growth of wind speed; this suppressed the effectiveness of wake mixing where the aerodynamic performance of DVGs gradually converged to clean surface configurations. The flow measurements demonstrated that the deformation of DVG can lead to significant decrease in near-wall flow velocities close to the airfoil trailing edge and generate more dispersed vorticity distributions. To further investigate the linkage between DVG deformation and its wake mixing effectiveness, complementary tomographic particle image velocimetry measurements were conducted. The results indicated that the vorticity strength presented monotonic decay with the bending angle of DVG within both near and intermediate wake regions. The capability of DVGs passively adjusts their bending angle, and therefore, the airfoil lift coefficients provide a novel approach to reduce aerodynamic load fluctuations for aircraft within unsteady flows.

1 November 2020 in Physics of Fluids
Verified
Journal Article
Open access
PDF file
DSDhanush Bhamitipadi Suresh
Dhanush Bhamitipadi Suresh
Emmanuvel Joseph AjuEmmanuvel Joseph Aju
Emmanuvel Joseph Aju
Yaqing JinYaqing Jin
Yaqing Jin
The distinctive wake characteristics and aerodynamic loads of two side-by-side wall-mounted cylinders were experimentally studied under turbulent boundary layer flows with various gaps. Time-resolved particle image velocimetry was used to analyze the mean and unsteady wake features, whereas a high-resolution load cell was applied to measure the characteristics of lift and drag forces. The results show that the decrease in gap between two cylinders can effectively delay the wake recovery and suppress both the downwash and upwash flows near the top and bottom ends. Overall, with smaller gaps, the turbulence intensity near the top end becomes higher due to the stronger local velocity shear. The distribution of integral time scales indicates that the velocity fluctuations in the near wake region along the middle cylinder span are highly influenced by the local recirculation flows, whereas those near the top end are dominated by the mixing of boundary layer flows. By accounting the equivalent incoming velocity along the cylinder span, both lift and drag coefficient present a similar trend compared to the “infinite length” cylinder cases from previous works. Interestingly, different from cylinders with “infinite length,” no clear intermittency of aerodynamic loads was observed in the current work. This can be attributed to the suppression of two-dimensional vortex shedding due to the three-dimensional flow effects and strong background turbulence. The joint distribution of the lift and drag forces reveals that the lift fluctuations increase significantly with the growth of cylinder gaps, whereas that of drag force remains nearly constant.