Goksu Gorel

Prof. Dr. Goksu Gorel

Electrical Engineering, Manisa Celal Bayar University, Manisa, Turkey (Türkiye)
+1
orcid

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 March 2017 in Applied Sciences
Verified
Journal Article
Open access
PDF file
ECErtugrul Cam
Ertugrul Cam
GGGoksu Gorel
Goksu Gorel
HMHayati Mamur
Hayati Mamur
The use of renewable energy resources has created some problems for power systems. One of the most important of these is load frequency control (LFC). In this study, in order to solve the LFC problem, modern control methods were applied to a two area multi source interconnected power system. A photovoltaic solar power plant (PV-SPP) was also connected, in order to identify the harmful effects on the frequency of the system. A new Genetic-based Fuzzy Logic (GA-FL) controller was designed to control the frequency of the system. For comparison, conventional proportional-integral-derivative (PID), fuzzy logic (FL), and Genetic Algorithm (GA)-PID controllers were also designed. The new control method exhibited a better performance than the conventional and other modern control methods, because of the low overshoot and short settling time. All simulations were realized with the Matlab-Simulink program.

17 December 2018 in Elektronika ir Elektrotechnika
Verified
Journal Article
Closed access
PDF file
ZCZafer Civelek
Zafer Civelek
GGGoksu Gorel
Goksu Gorel
MLMurat Luy
Murat Luy
NBNecaattin BARIŞÇI
Necaattin BARIŞÇI
ECErtugrul Cam
Ertugrul Cam
A control operation is the most important part of stabilization between load and frequency in a power system. The demand power change and the generated power change can disrupt the load-frequency balance. For this reason, the system frequency value should be controlled by some methods. In this study, a load frequency control was performed in a two-area power system. The renewable solar energy system and the interconnected power system were connected. In order to control the load-frequency balance, the classical PI, PID, Fuzzy Logic Controller (FLC) based PI and Bacterial Foraging Algorithm (BFA) based PI controller were separately designed and implemented to control the frequency value. All the trials were simulated and confirmed by the MATLAB/Simulink program. According to the results obtained from the control methods, the BFA-PI method provided better overshoots and BFA-PI had better settling times than the others.DOI: http://dx.doi.org/10.5755/j01.eie.24.6.22281

19 June 2025 in Renewable and Sustainable Energy Reviews
Verified
Journal Article
Closed access
KBKivanc Basaran
Kivanc Basaran
MLMáté Lőrincz
Máté Lőrincz
MAMohammad Hosein Alaei
Mohammad Hosein Alaei
RLRenata Rodrigues Lautert
Renata Rodrigues Lautert
PSPierluigi Siano
Pierluigi Siano
GGGoksu Gorel
Goksu Gorel

26 September 2022 in Energies
Verified
Journal Article
Open access
PDF file
DMDheyaa Ied Mahdi
Dheyaa Ied Mahdi
GGGoksu Gorel
Goksu Gorel
The Unified Power Quality Conditioner (UPQC) is one of the Custom Power devices (CP), and it mitigates both load current and supply voltage problems (voltage swells, sags, harmonics, etc.) simultaneously. By using CP, we are getting more familiar with renewable energy’s high penetration on the electrical grid because of its intermittent nature, which causes power flection. We are also using powered electronic devices, and non-linear loads produce harmonics that affect the voltage and current waveform. In this paper, a UPQC will be used with a sensitive load that is connected to a grid (grid–wind turbine) power system. The UPQC will operate under different disturbances such as phase-to-ground fault, non-linear load on the grid side, and non-linear load in parallel with the sensitive load, using pulse-width modulation and hysteresis as switching techniques. Simulation results using MATLAB/Simulink are used to compare the two pulsing-generating techniques and show that electrical power is continuously fed to the load in all disturbances with total harmonic distortion (THD) less than 5% for voltage and 4.5% for current.

7 September 2023 in Elektronika ir Elektrotechnika
Verified
Journal Article
Open access
PDF file
GGGoksu Gorel
Goksu Gorel
MAMahdi O. Abdi
Mahdi O. Abdi
In this paper, the increase in the quality of the rotor speed of wind turbines and the decrease in mechanical loads on the turbines are investigated. Adjusting the angle of the blade to the nominal wind speed, the rotor speed of the wind turbine is maintained at its nominal value. Using control methods (such as proportional integral (PI), genetic algorithms (GAs), and particle swarm optimisation (PSO)), different results can be recovered. In addition, individual control of the blade tilt angle allows us to reduce the mechanical loads on the turbine with the control methods. The wind turbine was modelled in Matlab/Simulink. The simulation results show that individual control of the blade tilt angle ensures the quality of the rotor speed of the wind turbine and reduces the balanced periodic loads on the wind turbine. In the first part, we study the wind turbine in a global way, as well as the method used to calculate them. Then, we discuss the FAST system, which was used to model the wind turbine, as well as the design of individual pitch angle control. As a result, it is possible to reduce the fatigue of the mechanical wind turbine parts. According to the study, the mechanical load for all three blades was reduced by an average of 44 % compared to the PI and PSO methods and by 1 % compared to the PI and GA methods. The control of the pitch angle in wind energy systems is performed with different control methods. The study analysis of the mechanical loads found that they are largely balanced. Winds that blow perpendicular to the turbine blades on the x-axis provide these loads.

1 August 2023 in Bulletin of Electrical Engineering and Informatics
Verified
Journal Article
Open access
PDF file
GGGoksu Gorel
Goksu Gorel
IFInas Fadhil
Inas Fadhil
Power quality (PQ) problems for renewable energy system (RES) is major challenge for using these systems. Amplitude, frequency, and waveform is important PQ parameters especially for standalone or isolated systems. In this paper we propose RES with wind turbine (WT) and permanent magnet synchronous generator (PMSG) to feed different loads (liner, non-liner) through AC-DC-AC converter. The PMSG operate with fuzzy logic inertia controller, to convert turbine torque form PU to Nm. The inverter stage in the converter operate according to proportional integral derivative (PID) controller with 3rd harmonic injection pulse width modulation (PWM) to regulate the AC voltage in load side. For the same case study and operating condition, we compared the result for system parameters when using ordinary PWM and using PID with 3rd harmonic injection. Voltages total harmonics distortion (THD) was less than 2% with liner loads, and 3.5% with non-liner load and the same was for current load, the voltage amplitude was between (1-1.03) PU under different wind speed by using the proposed controller.