Adhesive bonding is a widely used joining technique across various industries. Achieving uniform adhesive coverage over the entire surface without the formation of air pockets is crucial for creating strong and durable joints. Simultaneously, it is essential to minimise waste caused by material leakage at the edges. However, generating an optimal adhesive pattern to achieve the desired adhesive distribution after compression remains a challenge, as fluids tend to spread in a circular manner, while industry-relevant target geometries are typically non-circular. This paper investigates the application of Convolutional Neural Networks (CNNs) to optimise adhesive application patterns by utilising a simplified simulation model known as the Partially Filled Gaps Model (PFGM) to generate extensive training data. The CNN is trained to predict fluid distribution outcomes based on initial adhesive application patterns and addresses the inverse problem of determining an optimal application pattern to achieve a desired target distribution after compression. Two training approaches are introduced: a basic inverse model that utilizes a straightforward input–output data exchange, and a more advanced strategy that incorporates a forward model to improve accuracy. The forward model predicts the final distribution, enabling better refinement of the initial application patterns. The results demonstrate that the CNN-based approach is highly effective in generating optimal application patterns for adhesive bonds. Its primary advantage, compared to alternative methods, lies in its ability to achieve precise results within a short computation time. However, a significant drawback is the limited flexibility in accommodating variations in parameters.
The focus of this article is on the measurement of tire and road wear particles (TRWPs) during vehicle operation. The long-term objective is to determine the sources of particulate matter. Consequently, the development of sustainable tires can be supported in the future by identifying factors influencing the concentration of particulate matter in vehicle-based tire tests. In an initial campaign, a test vehicle was equipped with a total of seven low-cost sensors (LCSs) for measurement campaigns on an isolated outdoor test track. The purpose of this was to evaluate the particle measurements in combination with GNSS data and driving data such as acceleration and speed. The potential observed in the initial investigation led to further investigations with an advanced, interconnectable modular particle and environmental sensor system (iMPES), which was developed in-house. The iMPES records measurement data for PM10 via the PMS7003 and PM100 via the SDS198 at 1 Hz over a period of up to 6 h, using a mobile power supply. The findings of the study indicate a robust characterization of the particle concentrations over the temporal and local course of the campaign drives. The results demonstrate the potential of the method to be part of a methodology to differentiate the particle sources and to derive influencing factors on the particulate matter concentration. The paper proposes a methodology for the mapping and analysis of lap-based data on a normalized route. Consequently, an inquiry into the local and driving-dependent dynamics is conducted, alongside a comparison with driving data.